American Panel AP24BC250-3 user manual Initial Programming, buttons, for 3 seconds

AP24BC250-3, AP24BCF300-3, AP40BC350-3, AP40BCF450-3 Manual

PROGRAMMING

1. INITIAL PROGRAMMING

NOTE: Initial programming is preset at the factory. Use this section only if changes are desired. If no changes are to be made, skip to Page 17 ( 2. Programming the cycles ).

a.With the display reading "OFF", press ("START/STOP") for a few seconds.

OFF

b.To change the language, press or then

press .

INITIAL PROGRAMMING

SELECT LANGUAGE

ENGLISH

ENGLISH

Blinks

c. Enter the default password by pressing, in order, the		INITIAL PROGRAMMING
		ENTER PASSWORD:
and	buttons.	***
If the entered password is wrong the display will show,
		INITIAL PROGRAMMING
for 3 seconds:		WRONG PASSWORD
Then the controller will go back to step c.			TRY AGAIN
		TRY AGAIN	Blinks

NOTE: If a wrong password is introduced three times the controller will go into “OFF” state.

During the password typing, button can be used to delete one or more characters.

d. If you do not wish to change the password, press

.

To change the default password, press or

for "YES" then press .

INITIAL PROGRAMMING

CHANGE PASSWORD?

NO

The password will always be a combination of three of the six available cycles:

("SOFT", "HARD", "SHOCK", "DEF", "UV", "HEAT PROBE").

Type the new password, then press .

Be sure to remember the new password and keep a record of it in a safe place.

e.To change the year, press or then press .

INITIAL PROGRAMMING

SET YEAR

2006

2006(year)

Blinks

f.To change the month, press or then

press .

INITIAL PROGRAMMING

SET MONTH

07

07(month)

Blinks

14