Operators Manual
3.Cup Turret. Release the catch securing the cup drop unit and swing the unit away from the door. Remove the cup stack assembly from its packaging and carefully place it onto the cup drop unit. Ensure that the flat on the turret drive shaft locates with the flat in the cup turret mounting block. Remove the lid and fill the tubes with the correct size cups for the type of cup catcher fitted to the machine. Allow the
cups to drop into the tubes directly from the packaging. DO NOT touch the cups with your hands.
Important: Do not fill the tube directly above the cup dispense position. Allow the cup turret motor to rotate a full tube to the cup dispense position when the machine is powered up. Rotating the cup turret by hand will damage the mechanism.
Note: If paper cups are being loaded, each pack of cups must first be inspected for damage to the cup rims. Damaged cups must not be used.
4.Insert the safety key (a) supplied with the machine into the door switch as shown. The machine is now on. The cup turret mechanism will index the first available full cup stack to the dispense position and drop the cup stack into the cup drop mechanism. Fill the remaining empty cup stack with cups and replace the lid.
a
5.Swing the cup turret assembly back to its operating position. Ensure that the unit is held securely by the catch.
6.All Models: The water inlet valve will open and
the heater tank will start to fill. As the water heats, ensure that no water overflows from the heater tank overflow pipe into the waste bucket. When the machine has powered up, the LCD will display the message as shown opposite. Check the system for leaks.
Note! The machine has a safety
Espresso Models: As the machine initialises a small amount of water is pumped through the system and is discharged into the waste bucket. When the machine enters standby mode remove the bucket and empty the contents before refitting to the machine.
9