Jura Capresso ENA 5 12a. Using the Dual Frother Plus, Tips for frothing Cappuccino, Hotter milk?

12a. USING THE DUAL FROTHER PLUS

ENA 3 and 4 only: The Dual Frother Plus is already attached.

ENA 5 only: Remove the frothXpress (Fig. 20), and attach the Dual Frother to the steam nozzle. Make sure it is pushed up completely against the steam nozzle (Fig. 17).

Caution: If the Dual Frother is not attached properly or it is clogged (see chapter 12b) it is possible that the frother can be pushed off during steaming. This can cause burns and injuries.

Frothing Position: The cylinder of the frother is pushed down.

Steaming Position: The cylinder is pushed up (see Fig. 15).

READY

•Turn the Rotary Dial until the display shows STEAM.

•Push the Rotary Dial. The display shows HEATING. The ENA takes about 15 to 30 seconds to increase the temperature of the thermoblock system from hot water to steam.

•Fill the desired amount of milk into a pitcher or in your cup. Make sure that the pitcher or the cup has at least twice the volume of the milk, e.g. if you steam or froth 5 oz. of milk use a 10 to 12 oz. pitcher.

•When the display shows READY, immerse the frother into the milk (Fig. 16) and turn the Selector Switch to the hot water/ steam position. The display shows STEAM. Steam will be injected into the milk.

•With the cylinder pushed down (Fig. 15) small frothing bubbles will build up on the surface.

•With the cylinder pushed up, steam will heat up the milk with out creating froth.

IMPORTANT:

When you are finished with frothing/steaming turn the Selector Switch back to the coffee position. The display shows READY. Steam output will stop. Now remove the pitcher or the cup from the frother.

Please note: Within the next 40 seconds you can steam/froth more milk by simply turning the Selector switch back to the steaming position.

Tips for frothing (Cappuccino):

•The frother tip should not touch the bottom of your pitcher. Start in the steaming position – cylinder "up" (Fig. 15) – for a few seconds. Then push the cylinder "down". Milk froth will build up. This way the froth on top of your milk is also warm.

•Steaming and frothing directly in your cappuccino/latte cup: With practice, you can steam and froth directly in your cappuccino cup. First steam and froth the milk, then add your espresso shot.

Hotter milk?

If the frothed milk is not hot enough, continue in the steaming position.

12b. CLEANING THE DUAL FROTHER PLUS

Always keep the Dual Frother Plus clean. The two side holes and the groove of the frother tip must be free of milk deposits (Fig. 18). If these parts contain hardened milk particles, it will be impossible to froth milk properly.

Fast cleaning:

READY. Place a cup underneath the frother and turn the

17.