Jura Capresso ENA 5 Empty Tray, Manual Tablet Cleaning Cycle, Decalcifying, De-Scale /Ready

EMPTY TRAY.

9.Remove the cup and then the drawer and tray.

10.Empty drawer and ground coffee container and replace.

11.The display shows READY.

The machine will automatically remind you after the next 180 cups of coffee to repeat this cycle.

18.2 MANUAL TABLET CLEANING CYCLE

It is possible that the brewing process slows down before the automatic message (chapter 18.1) appears. Dark beans may deposit more oils into the brewing chamber. When this happens you can manually start a tablet cleaning cycle as follows:

READY

•Push and hold the P button (Fig. 4) until display shows RINSE.

•Push the P button again. The display shows again RINSE.

•Turn the Rotary Dial until the display shows CLEAN.

•Push the Rotary Dial EMPTY TRAY

Continue with steps 2 through 11 in chapter 18.1

18.3 DECALCIFYING

The ENA has an integrated decalcifying program. This decalcify- ing program takes about 40 minutes. Your ENA is set in the fac- tory to automatically remind you when it is time to decalcify the machine. If you do not use the Clearyl filter, we recommend that you purchase one set of Jura decalcifying tablets (one set is good for three decalcifying procedures). See chapter 31. Please note: If you have installed and activated the Clearyl filter, the decalcifying program is inactive.

DECALCIFYING AGENT: Only use our special decalcifying tablets Model # 66281, chapter 31.

CAUTION:

•Avoid contact of the descaling agent with the skin or eyes. This can cause irritation. Rinse the descaling agent off with clear, clean water. Should you get descaling agent in your eyes, consult a doctor.

•Immediately remove any splashes or drops of the decalcifying agent from sensitive surfaces, such as natural stone or wood.

•Always wait until the decalcifying agent in the water tank has been used up. Do not fill additional decalcifying agent into the water tank.

•Never use vinegar or any other decalcifying agent. This might damage internal parts of the machine.

When the display shows DE-SCALE / READY it is time to decalcify the machine. You can still make coffee. However, it is highly recommended decalcifying the machine within the next 3 to 4 days.

Important: CLEARYL FILTER: If you use the Clearyl water cartridge and the display shows DE-SCALE / READY, then your cartridge function was not activated. Follow the instructions in chapter 17.1 to activate a new cartridge.

Important: The decalcifying program must not be interrupted.

DE-SCALE /READY

1.Remove the Dual Frother or the frothXpress from the steam nozzle (Fig. 17).

2.Open the cover behind the Rotary Dial and press the Rinse button (Fig. 4) The display shows EMPTY TRAY.

3.Remove the complete drawer with the grid and the used coffee container (Fig. 1, 12 to 14) and empty the tray and the used coffee container.

25.