Since the Water Hardness Selector is off, the machine will not remind you when to decalcify. This could clog and damage your machine.
17.3 MANUAL CLEARYL REPLACEMENT
If the filter is more than 2 months old and the display does not indicate to replace filter, replace as follows.
READY.
•Push and hold the P button until the display shows RINSE
•Push the button again. The display shows again RINSE
•Turn the Rotary Dial until the display shows FILTER
•Push the Rotary Dial. The display shows INSERT FILTER
•Continue with steps 3 to 12 in chapter 17.2 above.
17.4 DO NOT LET THE CLEARYL FILTER DRY OUT!
If the filter is not immersed in water for a few days the granular inside will dry out and will block any water from passing through.
•If machine is not used for a few days, always leave some water in the water tank. This way the filter will not dry out. Once you start using the machine again, fill the water tank with fresh water and process approx. 2 oz. of water through the hot water spout. Now you have fresh water for your first cup of coffee.
•If the machine is not used for a longer period of time, empty the water container and remove the CLEARYL filter. Fill a glass with at least 2 inches of water and immerse the filter. Place the glass in the refrigerator.
•When you use the machine again, install the filter.
18.AUTOMATIC CLEANING CYCLES 18.1 CLEANING WITH SPECIAL TABLET
The machine monitors how many coffees are brewed and how
often the rinsing program is activated. After approx. 180 coffees or 80 initial rinse cycles the display will show CLEAN / READY. You can continue to make coffee, however we highly recom- mend cleaning the machine as described below within the next few days. This cleaning program will remove oil
Important: Once the cleaning program has started do not interrupt the procedure.
CLEAN / READY
Make sure the water tank is at least half full.
1.Press the Rinse button (Fig. 4). Display shows EMPTY TRAY
2.Remove the complete drawer with the grid and the used coffee container (Fig. 1, 12 to 14) and empty the tray and the used coffee container. Note: Even if tray is empty it must be removed for 20 seconds.
3.Replace the complete assembly.
4.The display shows PRESS ROTARY
5.Place a cup underneath the coffee spouts and push the Rotary Dial. The display shows CLEANING and water comes through the coffee spouts. This process stops after a few times and the display shows ADD TABLET.
6.Open the
7.Close the
PRESS ROTARY.
8.Push the Rotary Dial. The display shows CLEANING. The machine starts the automatic cleaning program by dispensing water in intervals in the cup underneath the coffee spout. The program stops automatically and the display shows
24.