READY
1.Open the cover behind the Rotary Dial. (Fig. 1,5)
2.Push and hold the P button (Fig. 4) until the display shows
RINSE.
3.Turn the Rotary Dial until the display show FILTER –
4.Push the Rotary Dial. The display shows NO –
5.Turn the Rotary until the display shows YES ✓
6.Push the Rotary dial again to confirm. The display shows OK and then INSERT FILTER
7.Remove the Clearyl cartridge from its bag and rinse cartridge under water.
8.Remove the water tank, open the Clearyl filter holder (Fig. 6) and insert the cartridge with its tapered end down into the water container. Make sure it fits securely inside the fins.
9.Push down the Clearyl holder until it snaps in (Fig. 7).
10.Fill the water tank with fresh cold water and replace.
11.Place a 20 oz. container under the steam nozzle (Fig. 17).
12.Push the Rotary Dial. The display shows OPEN TAP.
13.Turn the Selector Switch to the hot water/steam position. FILTER RINSING. Approx. 16 oz of cold water is pushed through the filter and through the steam nozzle. The rinsing water might be slightly discolored. This is not harmful and does not affect the taste of your next coffee. The rinsing stops automatically. The display shows CLOSE TAP.
14.Turn the Selector Switch back to the coffee position.
HEATING. READY.
The filter is now activated.
Please note: As long as the filter is activated, the water hardness setting is automatically turned off.
17.2AUTOMATIC CLEARYL REPLACEMENT Eventually the filter needs to be replaced. Over time and depending on the amount of water, the filter will cease to work. The machine cannot monitor the time aspect. It monitors the water volume. After approx. 60 liters of water use (~2,000 oz.) the display shows alternating READY FILTER
1. Open the cover behind the Rotary Dial. (Fig. 1,5)
2. Press the Rinse button (Fig. 4). The display shows INSERT
FILTER
3. Remove and empty the water tank.
4. Open the filter holder (Fig. 6) and remove the old cartridge.
5. Remove the new Clearyl cartridge from its bag and rinse under water.
6. Insert the cartridge with its tapered end down into the water container. Make sure it fits securely inside the fins.
7. Push down the Clearyl holder until it snaps in (Fig. 7).
8. Fill the water tank with fresh cold water and replace.
9. Place a 20 oz. container under the steam nozzle (Fig. 17). 10. Push the Rotary Dial. The display shows OPEN TAP.
11. Turn the Selector Switch to the hot water/steam position. FILTER RINSING. Approx. 16 oz of cold water is pushed through the filter and through the steam nozzle. The rinsing stops automatically. The display shows CLOSE TAP.
12. Turn the Selector Switch back to the coffee position.
HEATING. READY.
Important: If the filter is older than two months it needs to be replaced, regardless how much water has been processed (see chapter 16.3). At that time the filter has lost its calcium sup- pressing abilities and calcium will build up inside the machine.
23.