Selector Switch to the Hot Water/Steam position (Fig. 5). Let hot water run through the frother for about 3 seconds and then stop. This will flush out any small milk droplets.
Thorough cleaning of the Dual Frother parts:
•Remove the Dual Frother from the Steam Nozzle (Fig. 17) and unscrew the tip from the rod (Fig. 18). Make sure the two side holes, the bottom opening and the groove in the tip are com- pletely free of any hardened milk deposits (use hot soapy water and a cleaning brush). Rinse all parts thoroughly with fresh water and replace. Make sure the tip is screwed on to the rod properly (handtight) and the frother is completely pushed up against the steam nozzle.
CAUTION: If the tip of the frother is blocked by hardened milk deposits it is possible that the frother can be pushed off during steaming. This can cause burns and injuries.
13.USING THE FROTHXPRESS SYSTEM ENA 5: standard equipment,
ENA 3 and 4: separately available.
The frothXpress system lets you produce hot steamed or frothed milk right into your cup(s). After becoming familiar with this attachment you will be able to get exactly the amount of frothed or steamed milk you want in your cup (refer to the video).
• Remove the red protective cap from the side of the frothXpress system and attach the milk hose (included in pouch with ENA 5) with the black connector into the opening of the frothXpress (Fig. 20).
• Insert the other end into your milk carton or any container with cold milk (Fig. 21).
Important: This system siphons milk and mixes it inside the
frothXpress with hot steam. It is necessary that all parts are connected tightly, otherwise the siphoning process will not work. Frothing Position: Point the dial between 12 and 2 o’clock. Turning the dial towards the 2 o’clock position will reduce the amount of froth but will increase the temperature of the milk. Milk will be siphoned, heated and frothed. Fig. 20 shows the 12 o'clock position.
Steaming Position: Point the dial between the 4 and 6 o’clock position. Milk will be siphoned and heated with no froth. For hotter milk move the dial more towards the 4 o’clock position. Steam Only Position: When the dial points to the 3 o'clock position, the siphoning of the milk is blocked. Only steam will pass through the frothXpress. Fig. 19 shows that exact position.
13a. MAKING CAPPUCCINO AND LATTE
(1) Making one Cappuccino
•
•Place your cup underneath the frothXpress (Fig. 21). READY.
•Make sure the dial of the frothXpress is in the range between 12 and 2 o’clock.
•Turn the Rotary Dial until STEAM is displayed and push the Rotary Dial. The display shows HEATING. The ENA takes about 15 to 30 seconds to increase the temperature of the thermoblock system from hot water to steam.
•When the display shows READY, turn the Selector Switch to the hot water/steam position. The display shows STEAM. The frothXpress starts siphoning the milk and delivers hot frothed milk into your cup.
•When you have enough frothed milk in your cup turn the
18.