Jura Capresso Complete Guide to Maintaining Your ENA 3 for Optimal Coffee Quality

4.Replace the complete assembly.

5.The display shows AGENT IN TANK.

6.Remove and empty the water tank. (The Clearyl filter should not be in the water tank!)

7.Dissolve 3 of the large square decalcifying tablets in a container with 18 oz. of water (0.5 liters) and pour the solution into the water tank and replace.

8.The display shows OPEN TAP.

9.Place a 20 oz. container under the steam nozzle (Fig. 17).

10.Turn the selector switch to the hot water/steam position. The display shows DE-SCALING. Descaling agent flows through the steam nozzle in intervals and will stop automatically after a few minutes.

11.When the display shows CLOSE TAP, turn the Selector Switch to the Coffee symbol. The display shows DE-SCALINGand the descaling agent cleans internal parts and releasing it into the ground coffee container and tray. This takes several minutes.

12.When the display shows EMPTY TRAY, remove the outside container, then carefully remove the drawer and empty the used coffee container and tray and replace all.

13.The display shows FILL WATER TANK. Remove the water tank, rinse thoroughly, fill with 16 oz. of fresh, cold water and replace. The display shows OPEN TAP.

14.Place a 20 oz. container under the steam nozzle (Fig. 17) and turn the Selector Switch to the hot water/steam position. The display shows DE-SCALING. Clean water will push through the steam nozzle removing all descaling liquids.

15.When display shows CLOSE TAP, turn the Selector Switch to the Coffee symbol. The display shows DE-SCALINGand

the cleaning procedures continues internally.

16.When the display shows EMPTY TRAY, remove the outside container, then carefully remove the drawer and empty the used coffee container and tray and replace all. READY.

17.Re-attach the Dual Frother or the frothXpress to the steam

nozzle.

The machine will automatically remind you when it’s time to decalcify again.

18.4 MANUAL DECALCIFYING

If you use very hard water it is possible that calcium builds up prematurely. If your coffee does not come out as hot as before it is a sign for calcium build-up. When this happens you can manually start a decalcifying cycle as follows:

READY

•Push and hold the P button (Fig. 4) until the display shows

RINSE.

•Push the P button again. The display shows again RINSE.

•Turn the Rotary Dial until the display shows DE-SCALE.

•Push the Rotary Dial EMPTY TRAY.

•Continue with steps 3 through 17 in chapter 18.3

18.5 RINSE CYCLE, MANUALLY

When you turn the ENA on, the display turns from HEATING to PRESS ROTARY. This will perform an initial rinse cycle. When the ENA is turned off, the system automatically rinses the machine if coffee had been brewed before.

Rinsing can also be initiated manually, e.g. after using pre-ground flavored coffee. Place a cup underneath the coffee spouts. ENA 5 only: turn the coffee spout to the rinsing position (Fig. 11).

26.