Sonance Keypad Backlighting Jumper, C4630 SE Keypad Connections, Connecting the IR Receiver

Figure 19:C4630 SE Keypad

Controller Ports

		C4630 SE HOME AUDIO SYSTEM
3. Connect the IR receiver’s 3-conductor ribbon cable to the keypad’s rear-
panel IR RECEIVER CONNECTION as shown in Figure 16. The connection
features a 3-pin removable connector similar to the ones used for the					FROM IR
speaker connectors. Insert the wires into the openings at the rear of the
					RECEIVER
connector and secure them by tightening the screws at the top of the					GROUND
connector.
					+12V (center)
• The gray wire on the ribbon cable is the DATA wire, the center wire is					IR DATA (white)
+12V and the remaining wire is GROUND.
Keypad Backlighting Jumper
The C4630 SE Main and Numeric Keypads have rear-panel Backlight				PIN 14
				NUMBERICKEYPAD
Jumpers (Figure 17) that allow you to adjust the amount	of keypad	C4630
backlighting to suit room lighting conditions and user preference.		MAIN		FOR
		KEYPAD
				RESERVED	Figure 16:
Position 1 = DIM; Position 2 = BRIGHT; remove the jumper	to turn the		•	PIN 1
backlight OFF.		1	2		Connecting the IR Receiver
					to the Keypad
Using needle-nose pliers, tweezers or a similar tool, carefully insert the
jumper in the desired position (see Figure 17). The factory default is
BRIGHT.

NOTE: Unless the backlight jumper is removed, the keypad backlighting
is always ON, even if the local zone and all zones are OFF.	1 2	1 2	1 2
C4630 SE Keypad Connections	DIM	BRIGHT	OFF
	Figure 17: C4630 SE Keypad
1. In direct runs from keypad to controller, pull a length of CAT5 wire from every key-
	Backlight Jumper
pad mounting location to the C4630 SE location. The maximum length of any single
CAT5 cable is 1000’.

2.Terminate each CAT5 cable with RJ45 connectors on each end. Follow the TIA 568B wiring standard (see Figure 18).

3.We strongly recommend testing your connections with an RJ45 network cable tester to check for cable continuity, miswiring, open connections, shorted connections or cross-pinning.

4.Connect the CAT5/RJ45 cable to the RJ45 Connection Jack on the back of the Main Keypad (see Figure 14, on page

18)and to the zone’s Keypad

Controller Port on the C4630 SE	RJ45 Connector			TIA 568B		Z	Z
(see Figure 19).	(Flat Side UP)			Wiring Standard
			PIN	COLOR	SIGNAL	O	O
		1		White/Orange	No Signal	N	N
			2	Orange	No Signal	E	E
			3	White/Green	No Signal
			4	Blue	IR Data	1	2
			5	White/Blue	Status
			6	Green	No Signal
			7	White/Brown	Ground
		8		Brown	+12V DC

Figure 18:

Keypad Connection RJ45 Pinout

20