Sonance Mounting the C4630 SE Keypads, External Keypad Power see Figure, Keypad Ribbon Cable

C4630 SE HOME AUDIO SYSTEM

Mounting the C4630 SE Keypads

NOTE: Do NOT mount the C4630 SE keypads in the same electrical box with AC house wiring, light switches, or any other high - voltage device or control . The keypads can share gang boxes with each other, or with other controls such as A/B speaker switches, infrared receivers and Volume Controls, if these other devices are rated as Class 2 devices according to the National Electrical Code .

1. If you are using both a Main and Numeric	Keypad, connect the		Ribbon Cable
Numeric Keypad’s 14-pin ribbon cable between both keypads.
• Connect the ribbon cable so that the wire with the red stripe
connects to Pin 1 on both keypads (see Figure 20).			PIN 14				PIN 14
2. Mount the keypad(s) in an appropriate J-box or P-ring as described				KEYPADMAINTOCONNECTION				KEYPADNUMBERICFORRESERVED
in Keypad Location on page 19.		C4630			C4630
		NUMERIC			MAIN
• The ribbon cable is long enough to allow a Main and Numeric		KEYPAD			KEYPAD
Keypad to be mounted side-by-side in a	double J-box. Either		•				•
keypad can be mounted left or right.
			PIN 1				PIN 1
		1	2		1	2

NOTE: If the ribbon cable	is connected incor rectly	the
Numeric Keypad (including	its backlighting) will	not	Numeric Keypad	Main Keypad
function .
			Red Stripe to Pin 1
External Keypad Power (see Figure 21)				Figure 20:
If you’re connecting 6 or fewer sets of C4630 SE Main and Numeric			Keypad Ribbon Cable
Keypads (one set in each zone) to the C4630 SE, leave the ZONE 4 – 6
KEYPAD POWER Switch in the INT (internal) position. No external keypad			power is
required.				F1AL 12VDC
				INT
If you’re connecting more than 6 sets of C4630 SE Main and Numeric Keypads to the				ZONE 4-6
				KEYPAD POWER
C4630 SE, set the ZONE 4 – 6 KEYPAD POWER Switch to the EXT (external) position. Connect				EXT
				RS-232
a 12VDC 1A external power supply (Sonance PS2 Power Supply, part #91352, available
separately) to the ZONE 4 – 6 KEYPAD EXTERNAL POWER connection to provide			adequate		12 VDC
					1.0 A IN
power for the keypads in Zones 4 – 6.				–	+
See the table on page 46 for information about powering K1 and K2 programmable
keypads.				Figure 21:
				Keypad External Power
				Connection

21