Installing The Grill Head

Figure 6a (LP gas model only)

1.Now that you've assembled the grill cart you can install the pre-assembled Grill Head. See Fig. 6a or 6b. If you haven't already done so, we suggest you open the Grill Lid and remove the packed components. Even with the compo- nents removed, this next step requires 2

people.

BE CAREFUL NOT TO PINCH FINGERS WHEN LOWERING HEAD ONTO CART

2.For LP Gas grills:

With an assistant, lift and position the Grill Head onto the grill cart. Place the Pre-assembled Valve Kit through the slot in side of Grill Head as illustrated in Fig. 6a. Align the 4 holes of the Bowl Side Panel to the threaded holes on the Cart Leg Bracket.

Thread the Ignition Wire into the Wire Fastener. Secure Wire Fastener to Right Rear Bowl location on Grill Head by using 1 of the 1/4"xl/2" Pattern Head Screws. Finish securing Grill Head to Cart by using 3 of the 1/4"xl/2" Pattern Head Screws provided.

3.For Natural Gas grills:

With an assistant, lift and position the Grill Head onto the grill cart. Place the Pre-assembled Valve Kit and Ignition Wire through the slot in side of Grill Head as illus-

trated in Fig. 6b. Align the 4 holes of the Bowl Side Panel to the threaded holes on the

Cart Leg Bracket. Secure firmly by using 4 of the 1/4"x 1/2" Pattern Head Screws provided.

Installing Manual Lighting Stick

GRILL

HEAD

CART

LEG

CART LEG -LEFT

Figure 6b (Natural

CART

LEG

BRACKET

CART LEG

- LEFT

BOWL SiDE

PANEL

tGN_TION WIRE FROM GRILL HEAD

WIRE

FASTENER

IGNITION WiRE

FROM GRILL HEAD

EMBLED

VALVE KIT

- RIGHT

gas model only)

GRILL HEAD

BOWLStDE

PANEL

VALVE KiT

IGNIT_ON WIRE

FROM GRILL HEAD

1.Attach the Manual Lighting Stick to the Left Bowl Support Bracket as shown in Fig. 7. Align the hole at the end of Manual Lighting Stick Wire with the threaded hole on the Left

Bowl Support Bracket. Tighten securely using the M4x8mm Pattern Head Screw.

Figure 7

OUTSIDE BOWL

PANEL-LEFT

M4xSmmPATTERN__

HEAD SCREW

MANUAL LIGHTIN'

STICK