Installing Side Shelf, Side Burner and Tool Holder Kit
Remove Side Burner from Side Burner Kit before installing.
1.Enlisting the aid of an assistant, attach Side Burner Frame to right side of grill. Attach Side Shelf
Frame to left side of grill as shown in Fig. 8a.
Align the 4 holes on Side Shelf Frame and Side Burner Frame with the threaded holes on left and
right Bowl Support Brackets. Tighten securely using 4 of the 1/4"x3/4" Pattern Head Screws provided.
2.Install the
Burner Frame. See Fig. 8b. Attach the Pre- assembled Valve Kit to the Side Burner Valve Hole
on the Side Burner Frame, as shown in Fig. 8b.
Align the 2 holes on the Side Burner Frame with the threaded holes on the Side Burner Valve
Bracket. Tighten securely using 2 of M4x8mm Pattern Head Screws and 2 Washers.
. Cut Fastening Band from Pot Support and set Pot support aside. Install the Side Burner through the top hole in Side Burner Frame and onto the Side Burner Valve. Make sure that opening at end of Side Burner Tube goes over tip of Side Burner Valve. Secure Side Burner with supplied Cotter Pin. See Fig. 8c or Fig. 8d Place Pot Support into position on Side Burner Frame.
Figure 8a
SIDE SHELF FRAME
GRILL HEAD
BOWL SUPPORT
Figure 8b
HOLESFORSIDE
BURNERVALVEKIT
SIDE BURNER
FRAME
4.Install the Control Knob to the Side Burner Valve Stem. See Fig. 8c or Fig. 8d
5.For LP Gas grills:
Connect the Ignition Wire terminal from Side Burner with the other from Grill Head. Unscrew 1/4" x 2" Pattern Head Screw from Right Cart Leg and fix Wire Plug "A" into Wire Fastener. Install Wire Fastener to Right Cart Leg. Tighten securely using the same screw. See Fig. 8c
CONNECTION
TUBE
GRILL HEAD
M4x8mm
PATTERN HEAD
SCREW AND
WASHER
Figure 8c (LP gas
SIDE BURNER
FRAME
EMBLED
VALVE KIT
RNER
VALVE BRACKET
model only)
SUPPORT
,SIDE
BURNER
COTTER PiN
BURNER
FRAME
FROM GRILL HEAD
CONTROL
KNOB
CART
WiRE
17FASTENER
WIRE
FROM SiDE BURNER
VALVE KIT
GAUGE
WiRE PLUG "A"