Kenmore 141.15337, 141.17337 Electrode Check Requires an Assistant, Customer Service Helpline at

Page 19

Ignitor Battery Installation - See Fig. 9

1.Unscrew both Ignitor Caps located on the grill Control Panel and remove the Contact and

Spring from each Ignitor Slot.

2.Place the manufacturer supplied AA battery into each Ignitor Slot. Be sure to place the

_

po_ &c_g _L_:]. _OL_.S_ Fig. 9

3.Place the Spring over the AA battery, then place the Contact on top of the Spring. Screw the Ignitor Cap back onto the grill Control Panel.

4.Remove any protective film from outside and inside of Grill Head.

IMPORTANT: Before use of this grill please refer to Cleaning Exterior Stainless Steel

Surfaces found on page 27 of this Owner's Manual.

Figure 9

IGNITOR SLOT

IGNITOR CAP,

SPRING

CONTACT

Electrode Check - Requires an Assistant

Before placing the cooking components into your

grill, ensure that the Spark Electrode Tip is properly positioned within each Gas Collector Box ( a

3-1/4" wide stainless mechanism found at the front between each set of Burners.) The easiest way to ensure this is to perform this Electrode Check:

1.Be sure all Control Knobs are set to "OFF" and open the Grill Lid.

2.Have an assistant stand behind to the right of the grill and look down at each Gas Collector Box. NEVER put your face inside Grill Head.

3.Press the Ignitor Cap. You should hear a "clicking" sound and your assistant should see a small blue spark within each Gas Collector Box. If a spark is present the Electrode Tips are properly positioned.

4.If no spark is seen the Spark Gap shown in Fig. 10 needs to be adjusted as follows:

Using an adjustable wrench, loosen the Inside Nut just until the Gas Collector Box can be maneuvered and turned upward.

The gap between the Spark Electrode Tip and Spark receiver should be approximately 3/16".

If the gap is wider than 3/16" use a pair of long nose pliers and gently squeeze the Gas Collector Box until the gap is correct.

Return the Gas Collector Box to its original horizontal position, secure the Inside Nut and try the Electrode Check again.

5.If no "clicking" sound is heard check the following common causes. If you need assistance call our

Customer Service Helpline at 1-888-317-7642.

Ignitor AA battery not installed properly.

Ignitor wires may be loose. Remove the AA battery, inspect the Ignitor Junction Box found

behind the Control Panel, and connect any loose wires.

Figure 10 - Side View Figure

GAS COLLECTOR BOX

19

Image 19
Contents Sears, Roebuck and Co Hoffman Estates, IL 60179 U.S.A OwnersManual Liquid Propane Gas GrillSears, Roebuck and Co., Dept WA Hoffman Estates, IL Full 1-YearWarranty on GrillLimited Warranty on Selected Grill Parts Warranty RestrictionsWhich offers a listed Overfill Prevention Device See Fig Natural gas model onlyTightening Tool Ref. # P05515102K Component Qty Purpose Actual Size and Quantity of Each Hardware Piece LPG GAS Model onlyComponent Qty Purpose Components Install WheelsNG GAS Model only LPG REF# Description PART# QTY MY-HeM E LP gas model only For LP Gas grillsInstalling The Cabinet Doors For LPG Gas grills NG gas model only Installing Manual Lighting Stick Installing The Grill HeadFor Natural Gas grills Model only Installing Side Shelf, Side Burner and Tool Holder KitRef. # P05515102K Electrode Check Requires an Assistant Customer Service Helpline atInstalling Cooking Components Fuel Gauge Display lasts for approximately Valve to the full OFF position. Turn clockwise to close Connecting a Liquid Propane Gas LP gas Tank To Your GrillChecking For LP Gas Leaks Install Grease Tray KitGas Lighting Instructions Basic Lighting ProceduresBack Burner Lighting Instructions Manually Lighting Your Grill by Match Annual Cleaning of The Grill Interior Cleaning The Cooking GridsCleaning The Flame Tamers Cleaning The Grease Tray and ReceptacleAnqoenp!oerd# Page Congratulations Grilling Pork Grilling Steak and RibsGrilling Hamburgers and Sausages Grilling PoultrySmaller Fish Fillets and Cubes Whole Fish and Whole FilletsBaking Techniques Rotisserie Cooking Tips for Using The Back BurnerBalancing the Food Preparing to Smoke Using The Smoker DrawerTips for Smoking DEEP-FRYING Techniques STIR-FRYING TechniquesDouble Salsa Burgers Onion BurgersChicago Style HOT Dogs HERB-PEPPER Sirloin Steak RIB EYE Steaks with Grilled GarlicBarbecued Ribs MUSTARD-GLAZED Halibut Steaks Marinated Tuna SteakAlmond Coated Trout Barbecued Chicken Southwest Chicken BreastsPizza on the Grill Traditional Holiday TurkeyGrilled Potato Skins Fresh Vegetable STIR-FRYVegetable recipe. Makes 4- 6 servings Ingredients Onion Blossoms800.827-6655 u.sA 806.S61-6665 ,Careda