Cleaning The Burner Tubes and Burner Ports
To reduce the chance of FLASHBACK the proce- dure below should be followed at least once a month
in late summer or early fall when spiders are most active or when your gdll has not been used for a period of time.
1.Turn all Burner Valves to the full OFF position.
2.Turn the LP gas tank valve to the full OFF position.
3.Detach the LP gas regulator assembly from your gas grill.
4.Remove the Cooking Grids, Flame tamers, and Grease Trays from your gdll.
5.Remove the Cotter Pin from the rear underside of each Burner using a pair of long nose pliers.
6.Carefully lift each Burner up and away from the Gas Valve Orifice.
7.Refer to Fig. 1 and perform one of these three cleaning methods:
Bend a stiff wire, (a lightweight coat hanger works well) into a small hook as shown below. Run the hook through the Burner Tube and inside the Burner several times to remove any debris.
,)
Use a bottle brush with a flexible handle. Run the brush through the Burner Tube and inside the Burner several times, removing any debris.
Use an air hose to force air through each Burner Tube. The forced air should pass
debris or obstructions through the Burner and out the Ports.
Figure 1 | SPARK ELECTRODE AS- |
Ti(_ CLETAHNoBoUKRNERETE |
|
BURNER TUBE |
Regardless of which Burner cleaning procedure you
use, we recommend you also complete the following steps to help prolong Burner life.
1.Use a fiber pad or nylon brush to clean the entire outer surface of each Burner until free of food residue and dirt.
2. C ]59nany_ | Portsw Jha sd[fwe,suchas |
anqoenp:!oerd#. | |
, I_eachB_rd_n | age (c_d<sorho]es) |
andfsuchd_nage_ fund,o_erand_ | |
newB_.A_r | ils'ez]_tfn,check _Dexlstn_ |
&natd%eGasVa]]e0zJ£besa]e_]aced
i_f]e e endsof_eBumerTubes.Almche<k
&heposffnofy3urSpaJEL=_1]cde.
Z_WARNING
The location of the Burner Tube with respect to the Orifice is vital for safe operation. Check to ensure the Orifice is inside the
Burner Tube before using your gas grill. See Fig. 2. If the Burner Tube does not fit over the Valve Orifice, lighting the Burner may cause explosion and/or fire.
Figure 2
GAS VALVE ASSEMBLY
ORIFICEBURNER TUBE
GAS COLLECTOR BOX
'o/_
COTTER PIN
28