Kenmore 790.75603 manual Before Setting Surface Controls, Locations of the Gas Surface Burners

Page 10

Before Setting Surface Controls

Locations of the Gas Surface Burners

The STANDARD sized burners are used for most surface cooking needs. These burners are located at the left and right rear positions on the cooktop.

The SIMMER burner is used to simmering delicate aliments as chocolate, sauces, etc. This burner is located at the center rear position on the cooktop

The POWER burners are best used for bringing large quantities of liquid rapidly up to temperature or when preparing larger quantities of food. These burners are located at the left and right front positions on the cooktop.

Placement of Burner Bases and Caps

Place the burner base over each gas orifice, matching the burner base size with

the gas

orifice size. Place the burner

cap

Grate Pin

on each

burner base,

again matching

the

 

cap size

to the burner

base size. The cap

 

for each

Burner has a

inner locating

ring

 

Make sure each burner cap is properly aligned and level.

Turn the burner on to deter-

mine if it will light. If the burner

does not light, contact a Sears Service Center. Do not service

which locates the burner cap in the center

the sealed burner yourself.

of the burner.

Grate

Burner

Ca

Burner

 

Gas

Orifice

Electrode must be located

properly in slot of each

Burner Base

Alignment fork

Placement of Burner Grates

Cen_r

Alignment

Finger

Place grate over the burners. Place the alignment fork of the center grate over the alignment finger of the side grates. Align the tips under each center of the grate to the holes on the burner caps. The tip should fit in the holes. Make sure that each tip fits in the burner cap of each of the front and rear burners.

S / 4_.--Cooktop

10

Image 10
Contents Dual Fuel Range Estufa de dual fuel Model/ModeloContents Important Safety Instructions Important Instructions for Using Your Cooktop For Glass Cooktops onlyProduct Record Important Instructions for Using Your OvenSerial Plate Location Important Instructions forRange features CooktopCorrectincorrect Surface CookingConversion to Liquefied Petroleum Gas or L.P. Gas Cookware Material typesCanning Tips & Information Specialty Pans & TrivetsPrevent damage to cooktop Using the Wok Stand To properly position the Wok StandPlacement of Burner Grates Before Setting Surface ControlsPlacement of Burner Bases and Caps Locations of the Gas Surface BurnersOperating the Gas Surface Controls Setting Surface ControlsSetting Proper Surface Burner Flame Size Flame Size Type of CookingLocations Before Setting the Oven Controls Oven Vents and RacksOven Vent Locations Arranging Oven Racks Main Oven Side Oven200 Setting Side Oven ControlBroil 300Control Pad Features Minimum and MaximumInstructions Press Setting Oven ControlsSetting the Clock To set the clock example Below forInstructions DisplaySetting Silent Control Operation Setting Oven Lockout FeatureTo activate the Oven Lockout feature Instructions Press DisplayCelsius to Fahrenheit Setting Temperature Display --Fahrenheit or CelsiusTo change display from Fahrenheit to Celsius or PressdisplayTo set the Preheat temperature for 375F Setting PreheatPreheat Setting Bake To set the Bake Temperature to 375FOven Baking General Convection Bake Instructions Setting Convection BakeTemperature to 375F To set the oven for Convection BakeSetting Convection Roast Setting Convection ConvertSetting the Slow Cook Feature When the timed bake finishes Do,or Convect onSetting Delayed Timed Bake or Delayed Timed Convection Bake When the set bake time runs outCakes Setting the Food Categories FeatureTo set the Food Categories feature example for Cakes to cook at 375FTo set Warm & Hold Setting the Warm & Hold TM FeaturePress Display To set Warm & Hold to turn on automaticallyDetermining Broiling Times PreheatingBroiling Tips To set the oven to broil at 500F Setting BroilBroiling Times and Searing Grill Least 3 seconds. SAb will disappear from the display Figure To Quickly Erase all Stored Recipes To Set the Recipe Recall FeatureTo Program the Oven to Begin Baking with a stored 375CWhat to Expect during Cleaning Self-CleaningSelf-Cleaning Oven Adhere to the following cleaning precautionsWhen the Self-Clean Cycle is Completed Self-CleanCycle Time LengthStopping or Interrupting a Self-Cleaning Cycle When the Self-CleanCycle is Completed To Start the delayed Self-Clean CycleI21111 To adjust the oven temperature higher Adjusting Oven TemperatureStopping or Interrupting a Self-Cleaning Cycle To adjust the oven temperature lowerTo Clean the Oven Bottom Cleaning SideOvenGeneral Cleaning Porcelain Enamel OvenPlastic or foods with a high sugar content Ceramic Glass Cooktop Cleaning & MaintenanceFor heavy, burned on soil To Clean the Burner Caps To Clean the Contoured Burner PansTo Clean the Grates To Clean the Burner Bases and Gas OpeningsVinyl Stainless SteelTo Change the Oven Light Storage DrawerTo Remove and Replace Right Oven Door To Remove Storage Drawer To Replace Storage DrawerBefore You Call Metalmarks Protection Agreements Master Protection AgreementsPage Our Home Call anytime, day or night U.S.A. and Canada