Kenmore 790.7937, 790.7936 manual Changing Oven Lights, To replace the oven light bulbs

Page 40

General Care & Cleaning

Cleaning Recommendations

Special Caution for Aluminum

Changing Oven Lights

for the Ceramic Glass Cooktop (for models with a Ceramic Glass Cooktop only) Use on the Ceramic Cooktop (for models with a Ceramic Glass Cooktop only)

Do not use the following on the ceramic glass cooktop (for models with a

Ceramic Glass Cooktop only):

Do not use abrasive cleaners and scouring pads, such as metal and some nylon pads. They may scratch the cooktop, making it more difficult to clean.

Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners, as they may etch or discolor the cooktop.

Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint on the cooktop which can burn and cause discoloration.

Special Caution for Aluminum Use on the Ceramic Cooktop (for models with a Ceramic Glass Cooktop only)

Aluminum Foil - Use of aluminum foil on a hot cooktop will damage the ceramic cooktop. Do not use thin aluminum cooking utensils or allow aluminum foil to touch the ceramic cooktop under ANY circumstances.

Aluminum utensils - The melting point of aluminum is much lower than that of other metals. Care must be taken when aluminum pots or pans are used on the ceramic cooktop. If allowed to boil dry, not only will the utensil be destroyed, but it may fuse to, break or mark the ceramic glass surface, permanently damaging the ceramic cooktop surface.

Changing Oven Lights

The oven lights automatically turn ON when the door is opened. The oven lights may also be manually operated by pressing

the @ pad. The oven light bulbs are located at the rear of the oven and are covered with a glass shield held by a wire

holder. The glass shields must be in place whenever the oven is in use.

Be sure the range is unplugged and all parts are COOL before replacing oven light. Weara leather-faced glove for protection against possible broken glass.

Wire

Holder

To replace the oven light bulb(s):

1.Turn electrical power off at the main source or unplug the range.

2.Press wire holder to one side to release the glass shield.

3.Replace bulb with a new 40 watt appliance bulb.

4.Replace glass shield over bulb and snap wire holder into place.

5.Turn power back on again at the main source (or plug the range back in).

6.The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Guide.

40

Image 40
Contents Estufa a gas Contents Important Safety Instructions Important Instructions for Using Important Instructions for Cleaning Your RangeImportant Safety Notice For CERAMIC-GLASS Cook TOP Models some modelsGrounding Instructions Conversion to Liquefied Petroleum Gas or L.P. GasSears Installation Service Maintenance AgreementsSears Maintenance Agreement U.S.ABefore Using Your Range 9k!iiN t ,3Range Features Your Elite Gas Range Features IncludeBefore Setting Oven Controls Oven Vent LocationRemoving & Replacing Oven Racks Types of Oven RacksBefore Setting Surface Controls Baking Layer Cakes with 1 or 2 Oven RacksAir Circulation in the Oven Control Locations of the Gas Surface BurnersSetting Proper Surface Burner Flame Size Surface CookingOperating the Gas Surface Burners Size Type of CookingFig2 Operating the Bridge Burner for Bridge Burner models onlySetting Warmer Drawer Controls Using the GriddleUsing the Warmer Drawer Care & Seasoning of the GriddleWarmer Drawer Recommended Food Settings Table Food Item To Set the Warmer Drawer & Bread Proofing ControlsWarmer Drawer Removal Preparing Bread Dough for the Warmer DrawerTo Remove and Replace Warmer Warm & Ready TM Drawer To Remove Warmer DrawerControl Pad Settings Electronic Oven Control Pad FeaturesMinimum & Maximum Setting Oven Controls Setting the ClockTo set the clock example below for PressdisplaySetting Continuous Bake or 12 Hour Energy Saving SettingTo set the Kitchen Timer example for 5 minutes To cancel the Kitchen Timer before the set time has run outSetting Oven Lockout Feature To activate the Oven Lockout featureSetting Temperature Display m Fahrenheit or Celsius To reactivate normal oven operationSaving and Recalling Recipe Settings Setting Silent Control OperationFor 7seconds Setting Preheat To set the Preheat temperature for 350FTo set the Bake Temperature to 350F Setting BakeInstructions Setting Timed Bake Bake finishesTo program the oven for a Delay Start Delayed Timed Setting Delay StartWhen the set bake time runs out To set the oven to broil at the default setting 550F BroilingSearing Grill RecommendedSetting Food Categories Features MeatsCakes Breads @ PadsSetting Convection Bake To set the oven for Convection Bake Temperature to 350FCakes have better results when baked using the Cakes Pad Tips for Convection BakeTo set the Convection Convert feature To Set Add 1 Minute FeatureSetting the Slow Cook Feature Optional @Setting the Sabbath Day Feature Setting the Warm & Hold TM Feature To set Warm & HoldPRESS,,2 To set Warm & Hold to turn on automaticallySelf-Cleaning Oven Self-CleaningAdhere to the following cleaning precautions Clean will flash, 300 hours Press 200 to 400 using Number padsWhen the Self-Clean cycle is done Stopping or Interrupting a Self-Cleaning cycleAdjusting Oven Temperature To adjust the oven temperature higherTo adjust the oven temperature lower Press DisplayGeneral Care & Cleaning How to CleanSurfaces Glass control panelRemoving & Replacing the Lift-Off Oven Door Care & Cleaning of Stainless Steel some modelsDoor Care Instructions Cleaning the Cooktop, Burner Heads, Caps & Grates Cleaning Recommendations for the Ceramic Glass Cooktop Plastic or foods with a high sugar contentFor models with a Ceramic Glass Cooktop only For light to moderate soilChanging Oven Lights To replace the oven light bulbsBefore You Call Possible CAUSE/SOLUTION Self-Cleaning sectionOccurrence ScratchesorabrasionsoncooktopsurfaceRecipes for Slow Cook Slow Cook Turkey BreastMY-HOME Our HomeCanada Call anytime, day or night U.S.A. and Canada