Kenmore 790.7936, 790.7937 manual Before Using Your Range, 9k!iiN t ,3

Page 7

Before Using Your Range

Assembly of Burner Heads & Burner Caps (for Deep Well Cooktop models only)

Your range is shipped with the Burner Heads and Burner Caps in the correct locations. the Burner Heads and Burner Skirts.

1.Be sure to follow the Installation Instructions before installing and using your new range.

2.

Remove all packing tape from cooktop area. Remove all

 

I

 

 

 

 

 

Burner Caps and Burner Heads.

 

 

Burner

 

3.

Discard all packing

material located

under Burner Heads.

 

Cap

 

 

 

 

4.

To replace Burner

Heads & Caps, match the letters

 

 

 

 

located under center of Burner Caps with the letters

 

 

 

 

located inside Burner Heads (Fig. 1).

3urner

(

)_

5.

Match the letters stamped on Burner Skirts with Burner

Head

1_ _::D_. _?://

 

Heads and Burner Caps (See Fig. 1). Replace the Burner

 

 

::

 

 

Heads and Caps on cooktop (See Fig. 2). Carefully align

 

 

 

 

 

 

 

the Electrodes into slot or hole of each Burner Head (Fig.

 

 

 

 

3). Note: The Burner Heads should

sit flat on Cooktop

_.

BumerS-k_t

j

 

Burner Skirts.

 

 

Fig.1

 

 

6.

Unpack Burner Grates and position

on the cooktop.

 

 

 

Packing material is located between

Fig. 2

 

Electrodes

must

 

align into slot or hole for each

Fig. 3

Burner

Head

Assembly of Burner Heads & Burner Caps (for Ceramic Glass Cooktop models only)

;_,

Your range is shipped with the Burner Heads and Burner Caps in the correct locations. Packing material is located between the Burner Heads and Burner Skirts.

1.

Be sure to follow the Installation Instructions before

 

installing and using your new range.

2.

Remove all packing tape from cooktop. Remove Burner

 

Caps and Burner Heads (See Fig. 4).

3.

Discard all packing material located under all Burner

 

Heads.

8ridg_ B urner

3 p_sltlon_

:

_'S %: (notm_rked)

A

I

Burner

Cap

4. To replace Burner Heads & Caps, match the letters

located under center of Burner Caps with the letters

located inside Burner Head (only positions A & F are

marked with letters - See Fig. 5). Place all Burner Heads

& Caps on the cooktop (See Fig. 4) while carefully

aligning the Electrodes into slots or holes of the Burner

Heads (Fig. 7). Note: The Burner Heads should sit flat on

Cooktop Burner Skirts.

5. Replace Bridge Burner Caps. These include one Bridge

Burner Center Cap (rectangular shaped) and the two

Bridge Burner End Caps (The Bridge Burner End Caps will

fit either the front or rear Bridge Burner Head locations).

Make sure that the tabs located under the Bridge Burner

Caps fall into the slots located in the Bridge Burner Head

(See arrows in Fig. 6) and that all the Bridge Burner Caps

lie flat and evenly on the Bridge Burner Head.

6. Unpack Burner Grates. NOTE: Do not force End Burner

Grates down on cooktop. Be careful to line up the 2 Grate

Pins located on each of the 2 End Burner Grates into the

Pilot holes located on top of the Burner Caps (See Fig. 8).

Position Burner Grates on cooktop and check that all the

Burner Grate legs lie on the glass surface.

7. Place Center Burner Grate between the end Burner

Grates.

9k!:iiN] t_ :,3)

............. 7.2k

ii

Fig. 4

Bridg I Burner Head

Bridge

Burner

End

Cap

Bridge

Burner

Center

Cap

Bridge

Burner

End

Cap

!:. Burner Sk_rirt

R 5_

must align into slot or hole for each Burner Head

Fig. 7

Fig. 6

Fig. 8

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Estufa a gas Contents Important Safety Instructions Important Instructions for Cleaning Your Range Important Instructions for UsingConversion to Liquefied Petroleum Gas or L.P. Gas Important Safety NoticeFor CERAMIC-GLASS Cook TOP Models some models Grounding InstructionsU.S.A Sears Installation ServiceMaintenance Agreements Sears Maintenance Agreement9k!iiN t ,3 Before Using Your RangeYour Elite Gas Range Features Include Range FeaturesTypes of Oven Racks Before Setting Oven ControlsOven Vent Location Removing & Replacing Oven RacksControl Locations of the Gas Surface Burners Before Setting Surface ControlsBaking Layer Cakes with 1 or 2 Oven Racks Air Circulation in the OvenSize Type of Cooking Setting Proper Surface Burner Flame SizeSurface Cooking Operating the Gas Surface BurnersOperating the Bridge Burner for Bridge Burner models only Fig2Care & Seasoning of the Griddle Setting Warmer Drawer ControlsUsing the Griddle Using the Warmer DrawerTo Set the Warmer Drawer & Bread Proofing Controls Warmer Drawer Recommended Food Settings Table Food ItemTo Remove Warmer Drawer Warmer Drawer RemovalPreparing Bread Dough for the Warmer Drawer To Remove and Replace Warmer Warm & Ready TM DrawerControl Pad Settings Electronic Oven Control Pad FeaturesMinimum & Maximum Pressdisplay Setting Oven ControlsSetting the Clock To set the clock example below forTo cancel the Kitchen Timer before the set time has run out Setting Continuous Bake or 12 Hour Energy SavingSetting To set the Kitchen Timer example for 5 minutesTo reactivate normal oven operation Setting Oven Lockout FeatureTo activate the Oven Lockout feature Setting Temperature Display m Fahrenheit or CelsiusSaving and Recalling Recipe Settings Setting Silent Control OperationFor 7seconds To set the Preheat temperature for 350F Setting PreheatTo set the Bake Temperature to 350F Setting BakeInstructions Bake finishes Setting Timed BakeTo program the oven for a Delay Start Delayed Timed Setting Delay StartWhen the set bake time runs out Recommended To set the oven to broil at the default setting 550FBroiling Searing GrillBreads @ Pads Setting Food Categories FeaturesMeats CakesTips for Convection Bake Setting Convection BakeTo set the oven for Convection Bake Temperature to 350F Cakes have better results when baked using the Cakes PadTo Set Add 1 Minute Feature To set the Convection Convert featureOptional @ Setting the Slow Cook FeatureSetting the Sabbath Day Feature To set Warm & Hold to turn on automatically Setting the Warm & Hold TM FeatureTo set Warm & Hold PRESS,,2Self-Cleaning Oven Self-CleaningAdhere to the following cleaning precautions 200 to 400 using Number pads Clean will flash, 300 hours PressStopping or Interrupting a Self-Cleaning cycle When the Self-Clean cycle is donePress Display Adjusting Oven TemperatureTo adjust the oven temperature higher To adjust the oven temperature lowerGlass control panel General Care & CleaningHow to Clean SurfacesRemoving & Replacing the Lift-Off Oven Door Care & Cleaning of Stainless Steel some modelsDoor Care Instructions Cleaning the Cooktop, Burner Heads, Caps & Grates For light to moderate soil Cleaning Recommendations for the Ceramic Glass CooktopPlastic or foods with a high sugar content For models with a Ceramic Glass Cooktop onlyTo replace the oven light bulbs Changing Oven LightsBefore You Call Scratchesorabrasionsoncooktopsurface Possible CAUSE/SOLUTIONSelf-Cleaning section OccurrenceSlow Cook Turkey Breast Recipes for Slow CookCall anytime, day or night U.S.A. and Canada MY-HOMEOur Home Canada
Top Page Image Contents