Craftsman 107.289860, ZTS 6000 manual Remove the Packaging Materials, Check the Tire Pressure

Page 13

Remove the Packaging Materials

Remove the cardboard from the crate.

Remove any steel branding securing the unit to the crate. Locate the manual

packet.

Read the Operator's Manual

........... i

Locate the operator's manual in the manual packet. You should always read and follow the instructions in the operator's manual. Proper care, performance tips, and safety information are located in this important document.

Check the Tire Pressure

Reduce the tire pressures to the pressures shown below. Tires are over- inflated for shipping purposes and must be set to the correct pressures for optimum traction.

RearTire Pressure: 10-12 PSI

Front Tire Pressure: 18=20 PSi

Check Engine Oil Level

Note: Engine is shipped with off. Add

FUI10W-30 premium engine off if off level is low. See MAINTENANCE for complete engine oil specifications and maintenance requirements.

Lift the seat deck (Figure 15) to access the engine compartment.

Clean the area around the dip stick/oil fill tube. Remove the dip stick from the oil fill

tube and wipe the dip stick with a clean rag.

Insert the dip stick into the oil fill tube (thread in or push down completely).

Remove and check the engine oil level. Oil level should

be between Full and Add marks. If necessary, add oil to the oil fill tube.

Replace and fully secure the dip stick.

Charge the Battery

Lift the seat deck to access the battery. If the unit is being put into service after the month and year indicated on the battery date tag (located on top of battery) charge the battery for one hour at 6=10 amps. Refer to the SERVICE &

ADJUSTMENTS section of this manual for battery charging information.

Fill=Up with FRESH Gasoline

Lift the seat deck to access the

Remove the fuel tank cap and fill fuel cap and tank.

the tank with fresh fuel. After

\, ,.,,_,',_//_ fueling, securely install the cap and wipe up any fuel that may

have spilled. See the Operator's Manual for fuel recommendations.

The single most common service issue is stale or contaminated fuel! Fuel should not be more than 30

days old. Use fuel stabilizer to extend the life of your fuel, and always store fuel in an approved, sealed, plastic gas can. Stale fuel clean=out is not covered under your warranty.

Fuel Tank Capacity: 4.0 Gallons (15,14 L)

Start the Engine and Drive the Unit Off the Crate

Refer to the STARTING THE ENGINE and DRIVING PRACTICE sections of this manual for information on starting the unit and driving it off the crate.

13

Image 13
Contents For answers to your questions about this Product, call ZTSPage Assembly Warranty Statement Storage Safety Rules InformationIdentification Numbers Pre-Operation RepairTransporting and Storage General OperationChildren Towed Equipment RIDE-ON UnitsEmissions Ignition SystemOnly RiDE UP and Down Hill Suggested Guide for Sighting Slopes for Safe OperationService & Maintenance Service and MaintenanceSafe Handling of Gasoline Switch Safety & Operation DecalsEnglish and Spanish 16-18 x 3/4 Installing the SeatInstalling the Seat Safety Switch Installing the Seat Safety SwitchSetting Up the Ground Speed Control Levers Setting UP the Ground Speed Control LeversCheck the Tire Pressure Remove the Packaging MaterialsCheck Engine Oil Level Fill=Up with Fresh GasolineGround Control FunctionsSpeed Levers Parking Brake LeverGeneral Operating Safety Fuel Recommendations Checks Before StartingStopping the Rider & Engine Emergency StoppingStarting the Engine MowingForward Travel Practice Smooth TravelReverse Travel Practice Forward Travel Reverse TravelExecuting Turns Practice Turning Around a Corner Practice Turning In PlaceExecuting an End-Of-Row Zero Turn Turning In PlaceInstalling the Mower Deck Mower Deck Removal InstallationRemoving the Mower Deck Rider Maintenance Maintenance ScheduleMaintenance All ModelsClean Debris from Rider and Engine Compartment Accessing the Engine CompartmentClean Debris from Engine Cooling Areas and AIR Filter Check Tire PressureGrease LubricationFor your personal safety, blade mounting Clean Deck CHECK/REPLACE Mower BladesCapscrews must each be installed with two spring Check Rider Safety System Cleaning the Battery and CablesOperational Safety Checks Adjustment Nut Feeler Gauge Adjust PTO ClutchChange Engine OIL Check Engine OIL LevelChange Engine OIL & Filter Air Filter Removal & Installation AIR Filter & PRE-CLEANERReplace Spark Plug Speed Balancing Adjustment Ground Speed Control Lever AdjustmentCutting Height Adjustment PTO Clutch AdjustmentBattery Charging Brake AdjustmentEngine Adjustments For all moving parts to stop. Remove the keySide to Side Leveling Mower Deck Leveling AdjustmentsTrunnion Jam Nuts Front To Back Leveling Mower Belt ReplacementAfter Storage Before StorageWill Troubleshooting the RiderMower TroubleshootingZTS Page Reglas e Informacibn de Seguridad Declaracibn De GarantiaNdmeros de Identificacibn Partes de Refaccibn Operacibn Repare El Acuerdo De la MantenimientoTransporte Y Almacenamiento Operacion GeneralEquipo Remolcado Unidades Monta Operacion EN CuestasEmisiones Sistema DE EncendidoDoblar a LO LARGo DE LA Manejo Seguro de la Gasolina Servicio Y MantenimientoCALCOMANiAS DE Seguridad Y OPERAClON Llaves Recolector de Hierba con Bolsa Gemela Faro delanteroInstrucciones de Disposicion lngles/EspaSol Manual del Operador y Libro de Partes lngles/EspaSolFigura 1. Instalaci6n del asiento Instalacion DEL AsientoInstalacion DEL Interrupter DE Seguridad DEL Asiento 16-18 16-18 x 1-3/4 Revisar la Presi6n de las Mantas Retirar los Materiales de EmpaqueRevisar el Nivel de Aceite del Motor Cargar la BateriaPalancadeControl Control de Aceleracibn Estrangulador Choke-O-MaticPalancas deVelocidad PalancasdeVelocidad GasolinaInterruptor de Encendido Ajuste de Altura de Corte de laNterruptor de Cuchillas de la Palancas de Desembrague deVerificaciones Antes DE Arrancar ADVERTENCIA- RemolquesDetener EL Montable Y EL Motor Paro DE EmergenciaArrancar EL Motor Podar EL C¢SPEDTraslado sin prob- lemas Practica DE ManejoManejo Hacia AdelanteEjecutar Vueltas Practica de dar Vuelta en una EsquinaEjecutar un Giro Cero al Final de la Fila Practica de Vuelta en el LugarRetirar la Cubierta de la Sesgadora Remocion E Instalacion DE LA Cubierta DE LA SesgadoraInstalar la Cubierta de la Sesgadora Maintenimiento DEL Motor Programa DE MantenimientoAntes de Primavera Cada AnualLimpiar Despojos DEL Tractor Y DEL Compartimiento DEL Motor Ganar Acceso AL Compar Timiento DEL MotorFiltro DE Aire Verificar Presion DE LAS LLAN- TASLubricacibn del montable LubricacionFigura 25. Equilibrar el Aspa Figura 23. Remoci6n del AspaLos ojos Limpiar Baterja Y CablesVERIFICAR/AJUSTAR Embrague DEL PTO Verifique EL Nivel DE Aceite DEL Motor Y EL Filtro Verifique EL Nivel DE Aceite DEL MotorRemocibn e instalacibn del filtro de aire Servicio DEL Filtro DE Airey DEL PRE PurificadorEntrehierro de la Bujia Reemplace LA Bujja DEAjuste DE Embrague DEL PTO Ajuste DE Palanca DE Control DE VelocidadPara Ajustar la Altura de las Palancas de Control Recarga DE LA Baterja Ajuste DE LOS FrenosAjustes DEL Motor Nivelado de un Lado a Otro Ajuste DE Nivel DE LA Cubierta DE LA PodadoraFigura 40. Orientar las Aspas de Adelante hacia Atrs Nivelado de Adelante hacia AtrasAlmacenamiento MotorDel Tractor Diagn6sticoGadora es de Diagn6stico La sesgadoraImpulsa RepairParts ZTS 6000 Frame, Body & Seat GroupFootnotes Frame Body Seat GroupFrame, Body & Seat Group Lockwasher Engine Group 21HP Briggs & Stratton ZTS 6000 REF no Part QTY Engine Group 21HP Briggs & StrattonTransmission Group Transmission Group Transmission Group Transmission Group ZTS 6000 Controls Group 36 \Group Controls36 \ REF no Part NO. QTY. Description Electrical Group ZTS 6000 Lift Group Trunnion Wheel & Tire Group Tl/kWheel Tire Group Decals Group Decal Mower Deck Clutch & Support Group ZTS 6000 Mower Deck Clutch Support Group Mower Deck Housing & Arbor Group Cover ZTS 6000Cylinder Assembly Assemblies include all parts shown in frames 331877-0144-B1ZTS8000107 331 87701 44-B1 75o Zrs8000lo7- .28986o 331877-0144-B1zrsooolo7- .28988o Zrsooolo7- .28986o331877.-0144-B1 331877.-0144-B1 693551 Motor-Starter 802 691286 Cap-End 331 877-01 44-B1 Needle Eter PTS-40 PTS PTS Repair Protection Agreements Sears Installation ServiceAcuerdo de Proteccion de Reparaciones Servicio de Instalacion de SearsCall anytime, day or night U.S.A. and Canada Your Home