Craftsman 107.289860, ZTS 6000 manual Checks Before Starting, Fuel Recommendations

Page 16

CHECKS BEFORE STARTING

Check that the crankcase oil is filled to full mark on dipstick.

Fill the fuel tank with fresh fuel.

FUEL RECOMMENDATIONS

For daily operation: Use only unleaded gasoline with a pump sticker octane rating of 87 or higher. Gasohol (up to 10% ethyl alcohol, 90% unleaded gasoline by volume) is approved as a fuel. Methyl Teriary Butyl Ether (MTBE) and unleaded gasoline blends (up to a maximum of 15% MTBE by volume) are approved as a fuel. No other gaso- line/alcohol or gasoline/ether blends are approved. Do not use fuel additives other than fuel stabilizer.

For storage: CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

To avoid engine problems always use fuel stabilizer, especially before storage of 30 days or longer. Use fresh fuel next season. See STORAGE instructions for addi- tional information.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. To add fuel:

1.Remove the fuel cap (B, Figure 5).

2.Fill the tank. Do not overfill. Leave room in the tank for fuel expansion.

3.Install and hand tighten the fuel cap.

Figure 5. Pre-Start Checks

A. Fuel Tank Cap

WARNING

Never operate on slopes greater than 17.6 percent (10 °) which is a rise of 3-1/2 feet (106 cm) vertically in 20 feet (607 cm) horizontally.

Select slow ground speed before driving onto a slope. Use extra caution when operating on slopes with a rear-mounted grass catcher.

Mow across the face of slopes, not up and down.

Use caution when changing directions and DO NOT START OR STOP ON A SLOPE.

AWARNING

Never allow passengers to ride on the unit.

Before leaving the operator's position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key.

To reduce fire hazard, keep the engine, rider and mower free of grass, leaves and excess grease.

Do not stop or park rider over dry leaves, grass or combustible materials.

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area.

Avoid over-filling and wipe up any spills.

WARNING - TRAILERS

Do not load this zero-turnrider on a trailer or truck using two separate ramps. Only use a single ramp that is at least one foot wider than the width of the rear wheels of this rider. This rider has a zero turning radius and the wheels could fall off the ramps, or the rider could tip over injuring the operator or bystanders.

16

Image 16
Contents ZTS For answers to your questions about this Product, callPage Warranty Statement Storage Safety Rules Information AssemblyIdentification Numbers Pre-Operation RepairGeneral Operation Transporting and StorageTowed Equipment RIDE-ON Units ChildrenEmissions Ignition SystemSuggested Guide for Sighting Slopes for Safe Operation Only RiDE UP and Down HillService & Maintenance Service and MaintenanceSafe Handling of Gasoline Safety & Operation Decals SwitchEnglish and Spanish Installing the Seat 16-18 x 3/4Installing the Seat Safety Switch Installing the Seat Safety SwitchSetting UP the Ground Speed Control Levers Setting Up the Ground Speed Control LeversRemove the Packaging Materials Check the Tire PressureCheck Engine Oil Level Fill=Up with Fresh GasolineControl Functions GroundSpeed Levers Parking Brake LeverGeneral Operating Safety Checks Before Starting Fuel RecommendationsEmergency Stopping Stopping the Rider & EngineStarting the Engine MowingSmooth Travel Forward Travel PracticeReverse Travel Practice Forward Travel Reverse TravelPractice Turning Around a Corner Practice Turning In Place Executing TurnsExecuting an End-Of-Row Zero Turn Turning In PlaceInstalling the Mower Deck Mower Deck Removal InstallationRemoving the Mower Deck Maintenance Schedule Rider MaintenanceMaintenance All ModelsAccessing the Engine Compartment Clean Debris from Rider and Engine CompartmentClean Debris from Engine Cooling Areas and AIR Filter Check Tire PressureLubrication GreaseFor your personal safety, blade mounting Clean Deck CHECK/REPLACE Mower BladesCapscrews must each be installed with two spring Check Rider Safety System Cleaning the Battery and CablesOperational Safety Checks Adjust PTO Clutch Adjustment Nut Feeler GaugeChange Engine OIL Check Engine OIL LevelChange Engine OIL & Filter AIR Filter & PRE-CLEANER Air Filter Removal & InstallationReplace Spark Plug Ground Speed Control Lever Adjustment Speed Balancing AdjustmentCutting Height Adjustment PTO Clutch AdjustmentBrake Adjustment Battery ChargingEngine Adjustments For all moving parts to stop. Remove the keySide to Side Leveling Mower Deck Leveling AdjustmentsTrunnion Jam Nuts Mower Belt Replacement Front To Back LevelingBefore Storage After StorageTroubleshooting the Rider WillTroubleshooting MowerZTS Page Declaracibn De Garantia Reglas e Informacibn de SeguridadNdmeros de Identificacibn Partes de Refaccibn Operacibn Repare El Acuerdo De la MantenimientoOperacion General Transporte Y AlmacenamientoOperacion EN Cuestas Equipo Remolcado Unidades MontaEmisiones Sistema DE EncendidoDoblar a LO LARGo DE LA Servicio Y Mantenimiento Manejo Seguro de la GasolinaCALCOMANiAS DE Seguridad Y OPERAClON Recolector de Hierba con Bolsa Gemela Faro delantero LlavesInstrucciones de Disposicion lngles/EspaSol Manual del Operador y Libro de Partes lngles/EspaSolInstalacion DEL Asiento Figura 1. Instalaci6n del asientoInstalacion DEL Interrupter DE Seguridad DEL Asiento 16-18 16-18 x 1-3/4 Retirar los Materiales de Empaque Revisar la Presi6n de las MantasRevisar el Nivel de Aceite del Motor Cargar la BateriaControl de Aceleracibn Estrangulador Choke-O-Matic PalancadeControlPalancas deVelocidad PalancasdeVelocidad GasolinaAjuste de Altura de Corte de la Interruptor de EncendidoNterruptor de Cuchillas de la Palancas de Desembrague deADVERTENCIA- Remolques Verificaciones Antes DE ArrancarParo DE Emergencia Detener EL Montable Y EL MotorArrancar EL Motor Podar EL C¢SPEDPractica DE Manejo Traslado sin prob- lemasManejo Hacia AdelantePractica de dar Vuelta en una Esquina Ejecutar VueltasEjecutar un Giro Cero al Final de la Fila Practica de Vuelta en el LugarRetirar la Cubierta de la Sesgadora Remocion E Instalacion DE LA Cubierta DE LA SesgadoraInstalar la Cubierta de la Sesgadora Programa DE Mantenimiento Maintenimiento DEL MotorAntes de Primavera Cada AnualGanar Acceso AL Compar Timiento DEL Motor Limpiar Despojos DEL Tractor Y DEL Compartimiento DEL MotorFiltro DE Aire Verificar Presion DE LAS LLAN- TASLubricacion Lubricacibn del montableFigura 23. Remoci6n del Aspa Figura 25. Equilibrar el AspaLimpiar Baterja Y Cables Los ojosVERIFICAR/AJUSTAR Embrague DEL PTO Verifique EL Nivel DE Aceite DEL Motor Verifique EL Nivel DE Aceite DEL Motor Y EL FiltroServicio DEL Filtro DE Airey DEL PRE Purificador Remocibn e instalacibn del filtro de aireReemplace LA Bujja DE Entrehierro de la BujiaAjuste DE Embrague DEL PTO Ajuste DE Palanca DE Control DE VelocidadPara Ajustar la Altura de las Palancas de Control Recarga DE LA Baterja Ajuste DE LOS FrenosAjustes DEL Motor Ajuste DE Nivel DE LA Cubierta DE LA Podadora Nivelado de un Lado a OtroNivelado de Adelante hacia Atras Figura 40. Orientar las Aspas de Adelante hacia AtrsMotor AlmacenamientoDiagn6stico Del TractorGadora es de Diagn6stico La sesgadoraImpulsa RepairParts Frame, Body & Seat Group ZTS 6000Frame Body Seat Group FootnotesFrame, Body & Seat Group Lockwasher Engine Group 21HP Briggs & Stratton ZTS 6000 Engine Group 21HP Briggs & Stratton REF no Part QTYTransmission Group Transmission Group Transmission Group Transmission Group ZTS 6000 36 \ Controls GroupControls Group36 \ REF no Part NO. QTY. Description Electrical Group ZTS 6000 Lift Group Trunnion Tl/k Wheel & Tire GroupWheel Tire Group Decals Group Decal Mower Deck Clutch & Support Group ZTS 6000 Mower Deck Clutch Support Group Mower Deck Housing & Arbor Group ZTS 6000 CoverCylinder Assembly 331877-0144-B1 Assemblies include all parts shown in framesZTS8000107 331 87701 44-B1 75o Zrs8000lo7- .28986o 331877-0144-B1zrsooolo7- .28988o Zrsooolo7- .28986o331877.-0144-B1 331877.-0144-B1 693551 Motor-Starter 802 691286 Cap-End 331 877-01 44-B1 Needle Eter PTS-40 PTS PTS Sears Installation Service Repair Protection AgreementsAcuerdo de Proteccion de Reparaciones Servicio de Instalacion de SearsYour Home Call anytime, day or night U.S.A. and Canada