Craftsman 316.79479 manual Whileoperating, Other Safety Warnings

Page 3

WHILEOPERATING

Never start or run the unit inside a closed room or building,

Breathing exhaust fumes can kill. Operate this unit only in a well- ventilated outdoor area.

Wear safety glasses or goggles that are marked as meeting ANSI Z87.1 standards and are marked as such. Wear ear/hearing protection when operating this unit.

Never run the unit without the the proper equipment attached,

To reduce the risk of hearing loss associated with sound level(s), always wear ear/hearing protection when operating this unit.

Wear heavy long pants, boots, gloves, and a long sleeve shirt. Do not wear loose clothing, jewelew, short pants, sandals or go barefoot. Secure hair above shoulder level.

To avoid static electricity shock, do not wear rubber gloves or any other insulated gloves while operating this unit.

Use the unit only in daylight or good artificial light.

Keep outside surfaces free from oil and fuel.

Avoid accidental starting. Be in the starting position whenever pulling the starter rope. The operator and unit must be in a stable position while starting. Refer to Starting/Stopping Instructions.

Do not set unit on any surface except a clean, hard area while engine is running. Debris such as gravel, sand, dust, grass, etc. could be picked up by the air intake and thrown out by the discharge opening, damaging unit, property, or causing serious injury to bystanders or operator.

Use the right tool. Only use this tool for its intended purpose.

Do not force unit. It will do the job better and with less likelihood of injury at a rate for which it was designed.

Do not overreach or use from unstable surfaces such as ladders, trees, steep slopes, rooftops, etc. Always keep proper footing and balance.

Always hold the unit with a firm grip when operating.

Keep hands, face, and feet away from all moving parts. Do not touch or try to stop the impeller when it is rotating. Do not operate without guards in place.

Do not put any object into openings. Do not use with any opening blocked; keep free of dirt, debris, and anything that may reduce the air flow.

Do not touch the engine or muffler. These parts get extremely hot from operation, even after the unit is turned off.

Do not operate the engine faster than the speed needed to do the job. Do not run the engine at high speed when not in use.

Always stop the engine when operation is delayed or when walking from one location to another.

Stop the engine for maintenance, repair, to install or remove the blower tubes. The unit must be stopped and the impeller no longer turning to avoid contact with the rotating blades.

If you strike or come into contact with a foreign object, stop the engine immediately and check for damage. Do not operate before repairing damage. Do not operate the unit with loose or damaged parts.

Use only replacement parts recommended for this tool that are sold by a Sears outlet. Use of any replacement parts purchased elsewhere may be hazardous, and will also void your warranty.

Never use this unit for spreading chemicals, fertilizers or other substances which may contain toxic materials.

To reduce fire hazard, replace faulty muffler and spark arrestor. Keep the engine and muffler free from grass, leaves, excessive grease or carbon build up.

Turn the engine off and disconnect the spark plug for maintenance or repair.

Never point the blower or blowing debris in the direction of people, animals, or in the direction of windows. Always direct the blowing debris away from people, animals, and windows. Use extra caution when blowing debris near solid objects such as trees, automobiles, walls, etc.

OTHER SAFETY WARNINGS

Always disconnect the spark plug before performing maintenance or accessing movable parts. See Replacing the Spark Plug.

Never store the unit, with fuel in the tank, inside a building where fumes may reach an open flame (pilot lights, etc.) or sparks (switches, electrical motors, etc.).

Allow the engine to cool before storing or transporting. Be sure to secure the unit while transporting.

Store the unit in a dry place, secured, or at a height to prevent unauthorized use or damage. Keep out of the reach of children.

Never douse or squirt the unit with water or any other liquid. Keep handles dry, clean, and free from debris. Clean after each use, see Cleaning and Storage instructions.

Keep these instructions. Refer to them often and use them to instruct other users. If you loan this unit to others, also loan these instructions to them.

SPECIAL NOTE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swelling. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands or joints, discontinue use of this tool and seek medical attention. A reduced vibration system does not guarantee avoidance of these problems. Users who operate power tools on a

regular basis must closely monitor their physical condition and the condition of this tool.

SAVE THESE INSTRUCTIONS

Image 3
Contents INCREDI.PULLTM Safety Assembly Operation Maintenance Parts List ESPANOL, RRead ALL Instructions Before Operating Install the Accessory 753-05631Muffler AssemblySymbol Meaning Spark Arrestor NoteWhileoperating Other Safety WarningsION/OFF- Stop Control Safety and International SymbolsSafety Alert Symbol Wear EYE and Hearing ProtectionThrottle Grip Trigger LockAssemblingtheblowertube Installing the Flex TubeInstalling the Lower Blower Tubes and Nozzle Installing the Upper Blower TubeZip Tie Adjusting the Handle Zip Tie Hose ClampSecond Lower Blower Tube Mixing OIL and Fuel Mixing InstructionsUnleaded GAS Cycle OIL LitersStopping Instructions Starting InstructionsOperating Tips AdjustingthesuspensionsystemReleasing the Suspension System Holding the BlowerMaintenance Schedule Maintenance RequiredAIR Filter Maintenance Carburetoradjustment Spark Arrestor MaintenanceReplacing the Spark Plug Transporting CleaningStorage Long Term StorageCause CauseAction Cause ActionYour Warranty Rights and Obligations Owners Warranty ResponsibilitiesManufacturers Warranty Coverage California Evaporative Emission Control Warranty Statement Defects Warranty RequirementsEmission Warranty Parts List INCREDI.PULLT Simbolo Significado Indice DE ContenidosParachispas Proposicion 65 DE CaliforniaOtras Advertencias DE Seguridad DurantelaoperacionSimbolosdeseguridad Internacionales Cubiertadefiltro Manijadelacuerda Deaire dearranque Ensamblajedeltubodelasopladora Instalaci6n del tube flexibleInstalaci6n del tubo superior de la sopladora Control de Tube Del codeElbow Tube Manguera Tube flexible Cables ReguladorAceite DE 2 ClCLOS Mezclarelaceitey ElcombustibleArranque Pera del cebadorProcedimiento DE Operacion Para LA Sopladora AjustedelsistemadesoporteSostenimiento DE LA Sopladora Consejos Utiles Sobre LA OperacionMantenimiento DEL Filtro DE Aire Frequencia Mantenimiento Requerido VEAAjuste DEL Carburador Cambio DE LA Bujia DE EncendidoMantenimiento DEL Amortiguador DE Chispas Transporte LimpiezaAlmacenamiento Almacenamiento POR Largos Periodos DE TiempoCausa =11IV,11,t I#, IlIJ # , #II=1#, VllIIVP,WLista de Piezas de Emisiones en Garantia Los Derechos y Obligaciones de Usted segtn la GarantiaResponsabilidades del Propietario segtn la Garantia Cobertura de la Garantia del FabricanteLos Derechos y Obligaciones de Usted segOn la Garantia Requisitos de la Garantia por DefectosE16 E17 Description El8E19 Se q/rs