Troy-Bilt RZT manual Throttle Control, Choke Control, Parking Brake Engagement Lever

Page 12

The Indicator Monitor will also remind the operator of maintenance intervals for changing the engine oil. The LCD will alternately flash, “CHG” ; “OIL” and the recorded hours for five minutes after every 50 hours of recorded operation. The maintenance interval lasts for two hours (from 50-52, 100-102, 150-152, etc.). The LCD will flash as described for five minutes every time the tractor’s engine is started during this maintenance interval. Follow the oil change intervals provided in the engine manual.

Indicator Panel Features

Battery Indicator (Refer to Figure 4-4)

Illuminates and the battery voltage is displayed briefly when the ignition switch it turned to the “ON” position.

Illuminates to indicate the battery voltage has dropped below 11.5 (+0.5/-1.0) volts. The battery voltage is also displayed on the hour meter. If this indicator and display come on during operation, check the battery and charging system for possible causes and/or contact your Troy-Bilt dealer.

Oil Pressure Indicator (Refer to Figure 4-4)

This warning lamp indicates low engine oil pressure. If the indicator comes on while the engine is running, stop the engine immediately and check for possible causes. Do not run the engine while this indicator is illuminated. Contact your Troy-Bilt dealer to have the tractor and engine inspected.

NOTE: The oil pressure indicator may illuminate when the ignition switch is in the ON position, but should turn off when the engine is started.

PTO Engaged Indicator (Refer to Figure 4-4)

This indicator illuminates when the PTO switch is pulled upward in the “ENGAGED” position and the ignition switch is turned to the “START” position. Check this indicator if the engine will not crank with the ignition switch in the “START” position. If necessary, move the PTO switch to the “DISENGAGED” position.

Parking Brake Engaged Indicator (Refer to Figure 4-4)

This indicator illuminates when the parking brake is in the DISENGAGED position and the ignition switch is turned to the “START” position. Check this indicator if the engine will not crank with the ignition switch in the “START” position. If necessary, move the parking brake to the ENGAGED position.

This indicator also illuminates when the ignition switch is turned to the “START” position and the RH and/or LH drive control levers are in a position other than the fully out in neutral position. Move the control levers fully outward.

M.Throttle Control

The throttle control is located on the LH console to the left of the operator’s seat. When set in a given position, a uniform engine speed will be maintained.

Push the throttle control handle forward to increase the engine speed. The tractor is designed to operate with the throttle control in the fast position (full throttle) when the tractor is being driven and the mower deck is engaged.

Pull the throttle control handle rearward to decrease the engine speed.

This symbol indicates the fast position

This symbol indicates the slow position

N. Choke Control

The choke knob controls the position of the engine choke. Pull the knob out to choke the engine; push the knob in to open the choke.

O. Parking Brake Engagement Lever

The parking brake engagement lever is located on the front/left of the seat box frame, and is used to engage the parking brake.

Pull the lever fully upward and to the left; then lower into the short “J” slot to engage the brake.

Pull the lever up out of the “J” slot and to the right; then lower completely to disengage the parking brake.

IMPORTANT: If the LH and RH drive control levers are not fully opened out in the neutral position when engaging the parking brake, the engine will stop. The parking brake must be placed in the engaged position when starting the tractor engine.

Rear Bumper (Not Shown)

The tractor is equipped with a removable rear bumper. The rear bumper provides protection to the rear of the tractor frame and engine during turns.

The rear bumper must be removed from the tractor when installing a Rear Bagger Kit. Or you may want to remove the bumper to reduce the over-all length of the tractor. To Remove the rear bumper, proceed as follows:

•From the inside surface of the tractor frame, just rearward of the rear tire on either side of the tractor, pull the internal cotter pin from the clevis pin. Move to the other side of the tractor and remove the internal cotter pin from the other clevis pin. Refer to Figure 3-4 if necessary.

•While supporting the rear bumper, withdraw the clevis pin from both sides of the bumper, and pull the rear bumper rearward off of the tractor frame.

12

Section 4— Controls and Features

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Operator’s Manual Table of Contents To The OwnerThank You Record Product InformationImportant Safe Operation Practices California Proposition General OperationSlope Operation Do NotService General ServiceChildren TowingDo not modify engine Spark ArrestorAverage Useful Life Safe Operation Practices  Assembly & Set-Up Contents of CrateTractor preparation Connect the Battery Position Rear BumperLower Deck Discharge Chute Deflector Clevis Pin Internal Cotter Pin NotchDeck Height Index Deck Lift HandleRH and LH Drive Control Levers Ignition Switch Power Take-Off PTO SwitchSeat Adjustment Lever Not Seen Hour Meter / Indicator PanelIndicator Panel Features Throttle ControlChoke Control Parking Brake Engagement LeverGeneral Safety Safety Interlock SystemOperation Before Operating Your TractorUsing Jumper Cables To Start Engine Starting the EngineCold Weather Starting Parking BrakeStopping the Engine Practice Operation Initial UseDriving the Tractor Driving the Tractor ForwardDriving the Tractor In Reverse Turning While Driving RearwardStopping the Tractor Driving On SlopesExecuting a Zero Turn Using the Mower Deck Checking the Safety Interlock CircuitsPull the PTO switch upward to the Engaged position Operating The PtoMaintenance Air Cleaner Spark Plug Hydrostatic TransmissionGeneral Battery Information Battery MaintenanceTire Maintenance Using the Deck Wash SystemCleaning the Spindle Pulleys Using the Transmission Bypass RodsBattery Storage Using a fuel stabilizerTractor Storage Emptying the fuel systemAdjustments Adjusting RH & LH Drive Control LeversAdjusting the Operators Seat Removing The Tractor From StorageLeveling the Mower Deck Side to Side LevelingFront to Back Leveling Refer to FigureAdjusting the Gauge Wheels Maintenance Schedule Check Engine Oil LevelReplace Air Filter Element Service Battery RemovalCharging the Battery Servicing Electrical SystemDeck Installation Rolling the belt off the PTO pulleySupport Bracket SlotUsing the idler pulley to tension the belt Replacing the Deck Drive BeltRolling the belt into the PTO pulley Mower Blade Care Transmission Drive BeltBlades may be removed as follows Tractor Creeping Tractor High Speed TrackingConsole Jam Nut Stop Bolt Troubleshooting Problem Cause RemedyComponent Part Number and Description 759-3336 Spark Plug Champion RC12YCKH-12-050-01-S Kohler Oil Filter Kohler Fuel FilterComponent Part Number and DescriptionAttachments & Accessories Model Number Description590-303-000 Double Bagger 190-193-000 Mulch Plug MANUFACTURER’S Warranty Coverage MANUFACTURER’S Limited Warranty for Manual del operador Al propietario GraciasÍndice Registro de información de productoMedidas importantes de seguridad Proposición 65 de CaliforniaFuncionamiento general Funcionamiento en pendientes Haga lo siguienteNo haga lo siguiente Servicio NiñosRemolque Manejo seguro de la gasolinaNo modifique el motor Aviso referido a emisionesAmortiguador de chispas Vida útil mediaSección 2 Medidas de seguridad  Montaje y Configuración Contenido del cajónPreparación del tractor Instale el asiento del operadorConecte la batería Coloque el paragolpes trasero en posiciónBaje el deflector del canal de descarga de la plataforma Del borne sobre el borne negativo de la bateríaControles y Características Posicionamiento de la altura de la plataformaManija de elevación de la plataforma Interruptor de encendido Varilla de derivación de la transmisión no se vePortacubeta Bandeja de almacenamientoControl del regulador Control del cebadorPalanca de enganche del freno de mano Paragolpes trasero no se muestraFuncionamiento Seguridad generalAntes de hacer funcionar el tractor Sistema de bloqueo de seguridadEncendido del motor Arranque del motor en clima fríoUso de cables de puente para arrancar el motor Detención del motor Practique el modo de operación con el tractor uso inicialConducción del tractor PosiciónNeutral Más despacioGiro con el tractor en marcha directa Conducción del tractor en marcha atrásDetención del tractor Operación en pendientesGiro de radio cero Funcionamiento de la potencia de arranque Pto Uso de la plataforma de la cortadoraControl de los circuitos de bloqueo de seguridad Mantenimiento Mantenimiento de la batería Mantenimiento de los neumáticosLubricación Uso del sistema de lavado de la plataformaAlmacenamiento de la batería Almacenamiento del tractorSi guarda el tractor por 30 días o más Uso de un estabilizador de combustibleAjustes Ajuste del asiento del operadorDe la platafor ma TornilloHexagonal TuercaOuterhexagonalAjuste de las ruedas de calibración RebordeTuer ca de Tuerca de SeguridadCalendario de mantenimiento Servicio Retiro de la bateríaMantenimiento del sistema eléctrico Carga de la bateríaInstalación de la plataforma Corr‘V’ Bealt en V Tire de la polea locaDeslice la plataforma hacia adelante de modo que la Reemplazo de la correa de transmisión de la plataforma Uso de la polea loca para tensar la correaCorrea de la TransmisiónTubeCorrea de transmisión MénsulaIdlerPoleaPTO de la potencia PoleaDesplazamiento lento del tractor Desvío del tractor a alta velocidadContratuerca Solución de Problemas Problema Causa SoluciónPiezas de reemplazo Componente Número de pieza y DescripciónSección 9 Piezas de reemplazo Aditamentos y accesorios Número de modelo DescripciónCobertura DE LA Garantía DEL Fabricante Garantía Limitada DEL Fabricante Para

RZT specifications

The Troy-Bilt RZT is a formidable lawn mower that brings a blend of efficiency, performance, and user-friendly features to the forefront of lawn care. Designed for homeowners who demand both power and precision, the RZT series offers a riding mower experience unlike any other.

One of the standout features of the Troy-Bilt RZT is its innovative Zero Turn Technology, which enables exceptional maneuverability. This technology allows users to make sharp turns and navigate around obstacles with ease, ensuring precise mowing in tight spaces. The dual lever steering system enhances control, allowing for quick direction changes and saving time on larger properties.

The engine options available with the RZT series range from powerful V-twin engines to reliable OHV engines, providing homeowners with choices that cater to their specific mowing requirements. These engines ensure robust performance, delivering the horsepower needed to tackle even the toughest grass and terrain.

The RZT models come equipped with reinforced deck materials that result in superior durability. The cutting deck typically ranges from 42 to 54 inches, allowing users to cover more ground in less time while achieving a clean, professional cut. Additionally, the adjustable cutting height feature provides versatility, enabling users to customize their mowing height based on grass type and conditions.

Troy-Bilt enhances user convenience with features such as an ergonomic seat design, ensuring maximum comfort during extended mowing sessions. The easy-to-access controls and dashboard simplify operation, making it suitable for both novice and experienced users alike.

Maintenance is made straightforward with Troy-Bilt’s integrated maintenance reminders and easy-to-reach grease points for routine upkeep. The mower's mulch kit option allows for grass clippings to be finely chopped and returned to the lawn, promoting a healthier turf while saving time on clean-up.

Overall, the Troy-Bilt RZT combines powerful performance, advanced technology, and practical user-focused features to create a reliable riding mower. Whether managing a suburban lawn or a larger property, the RZT series proves to be a top contender for those seeking to maintain their outdoor space efficiently and effectively.
Top Page Image Contents