Wayne-Dalton 8850 installation instructions Cleaning Your Garage Door

Page 25

Cleaning

Cleaning Your Garage Door

IMPORTANT: DO NOT USE A PRESSURE WASHER ON YOUR GARAGE DOOR!

While factory-applied finishes on garage doors are durable, it is desirable to clean them on a routine basis. Some discoloration of the finish may occur when a door has been exposed to dirt-laden atmosphere for a period of time. Slight chalking may also occur as a result of direct exposure to sunlight.

Cleaning the door will generally restore the appearance of the finish. To maintain an aesthetically pleasing finish of the garage door, a periodic washing of the garage door is recommended.

The following cleaning solution is recommended

A mild detergent solution consisting of one cup detergent (with less than 0.5% phosphate) dissolved into five gallons of warm water will aid in the removal of most dirt.

NOTE: The use of detergents containing greater than 0.5% phosphate is not recommended for use in general cleaning of garage doors.

NOTE: Be sure to clean behind weather stripping on both sides and top of door.

CAUTION: NEVER MIX CLEANSERS OR DETERGENTS WITH BLEACH.

GLASS CLEANING INSTRUCTIONS

Clean with a mild detergent solution (same as above) and a soft cloth. After cleaning, rinse thoroughly.

ACRYLIC CLEANING INSTRUCTIONS

Clean acrylic glazing with nonabrasive soap or detergent and plenty of water. Use your bare hands to feel and dislodge any caked on particles. A soft, grit-free cloth, sponge or chamois may be used to wipe the surface. Do not use hard or rough cloths that will scratch the acrylic glazing. Dry glazing with a clean damp chamois.

NOTE: DO NOT USE any window cleaning fluids, scouring compounds, gritty cloths or solvent-based cleaners of any kind.

25

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

maintenance

Image 25
Contents Aluminum Full View Table of Contents Package Contents Door Section Identification Package ContentsP1 Removing An Old Door Tools RequiredSecurely attach a Preparing the OpeningFailure to Suitable mounting pad to structurallyConsult your Wayne-Dalton representative Tools Needed InstallationTo Bottom Brackets Bottom Section Hinges Installing Bottom SectionSection Inch track Stacking SectionsLift Handle Top BracketTop Section Step PlateFlagangle Adjusting Top BracketsCenter Bearing Bracket Torsion End Bearing BracketsTorsion Spring Assembly Attaching Torsion Springs to Center Bearing Bracket Securing Door Counterbalance CablesFor Spring Winding Winding Torsion Springs Keep horizontal track Rear SupportParallel and within 3/4 Maximum of door edge Otherwise door could fallThird roller. Insert a winding bar into Tools Needed To adjust spring tension, fully closeSet screws in the winding cone AgencyPull Rope Side LockTrolley Operator Or a double wide bottom rail Exhaust Port InstallationBoth sides of the door section Outside Trim Ring #10 Hex Nuts GasketCleaning Your Garage Door CleaningLimited Warranty Model Thank you for your purchase