Wayne-Dalton 8850 installation instructions Tools Required, P1 Removing An Old Door

Page 5

 

Tools Required

 

 

 

 

 

power drill

pencil

ratchet Wrench

vice grips

 

3/8”, 7/16” socket

gloves

 

 

 

 

 

 

driver

 

Phillips Head

7/16”, 1/2” &

9/32”, 1/2”, 3/16” & 1/8”

 

Safety Glasses

1/4”, 3/8”, 7/16”, 1/2” &

hammer

Screwdriver

9/16” Socket

drill bits

 

 

 

9/16” Wrenches

 

 

 

level

 

Tape Measure

 

vice clamps

 

sawhorse

Flat Tip Screwdriver

1/4” torx bit

Approved Winding Bars

 

 

Step Ladder

 

 

 

 

 

 

 

P1 Removing An Old Door

Counterbalance spring tension must always be released before any attempt is made to start removing an existing door.

WARNING

a powerful spring releasing its energy suddenly can cause severe or fatal injury. to avoid injury have a trained door systems technician, using proper tools and instructions, release the spring tension.

For detailed information see supplemental instructions “removing an existing door/preparing the opening”. These instructions are available at no charge from Wayne-Dalton Corp., P.O. Box 67, Mt Hope, OH 44660, or at www.wayne-dalton.com.

PRE-INSTALLATION

5

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Aluminum Full View Table of Contents Package Contents Door Section Identification Package ContentsP1 Removing An Old Door Tools RequiredSecurely attach a Preparing the OpeningFailure to Suitable mounting pad to structurallyConsult your Wayne-Dalton representative Tools Needed InstallationTo Bottom Brackets Bottom Section Hinges Installing Bottom SectionSection Inch track Stacking SectionsLift Handle Top BracketTop Section Step PlateFlagangle Adjusting Top BracketsCenter Bearing Bracket Torsion End Bearing BracketsTorsion Spring Assembly Attaching Torsion Springs to Center Bearing Bracket For Spring Winding Counterbalance CablesSecuring Door Winding Torsion Springs Keep horizontal track Rear SupportParallel and within 3/4 Maximum of door edge Otherwise door could fallThird roller. Insert a winding bar into Tools Needed To adjust spring tension, fully closeSet screws in the winding cone AgencyPull Rope Side LockTrolley Operator Or a double wide bottom rail Exhaust Port InstallationBoth sides of the door section Outside Trim Ring #10 Hex Nuts GasketCleaning Your Garage Door CleaningLimited Warranty Model Thank you for your purchase
Top Page Image Contents