Bottom Section


	3	Attaching Bracket Mount Track &
		Bottom Section

	Tools Needed:	Important: the tops of the vertical
	Tools Needed:	tracks must be level from side
		tracks must be level from side
	None	to side. If the bottom section was
	None	shimmed to level it, the vertical
		shimmed to level it, the vertical
		track on the shimmed side must be
		raised the height of the shim.
		Position the left hand vertical track
		assembly over the rollers of the bottom
		section. Make sure the counterbalance
		cable is located between the rollers and
		the door jamb. Drill 3/16” pilot holes into
		the door jamb for the lag screws.
		Loosely fasten vertical track assembly
		to the jamb using 5/16” x 1-5/8” lag
		screws. Tighten the bottom lag screw to
		jamb, to maintain 3/8” to 5/8” spacing as
		shown between the bottom section and
		vertical track. The other lag screws will be
		tightened in step, Top Section.
		Repeat for other side.
		Stack the bottom section into position by
		hooking the left hand roller into the left
		hand vertical track, as shown in FIG. 1.
		NOTE: Adjust the spacing of the vertical
		tracks from 3/8” - 5/8” spacing at the
		bottom section and 1-11/16” to 1-3/4”
		spacing at the top section.
		NOTE: Hang the counterbalance cables
		over the top of the flagangles as shown.

Wood Jamb

fIG 1

Counterbalance

Cable

Fig 1

Stack the section into position, by hooking the left hand roller into the vertical track and repeating for the right hand side.

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com