Wayne-Dalton 8850 installation instructions Side Lock, Pull Rope

Page 22

Side Lock

 

 

 

Tools Needed:

Install the side lock on the second section

of the door. Secure the lock to the section

 

Power Drill

with (4) 1/4”- 20 x 7/8” self drilling

screws. Square the lock assembly with

 

7/16” Socket

the door section and align with the square

Driver

hole in the vertical track. The side lock

 

should be spaced in approximately 1/8”

Tape Measure

from the section edge.

 

IMPORTANT: side locks must be

 

removed or made inoperative in the

 

unlocked position if an operator is

 

installed on the door.

 

NOTE: After completing this step, continue

 

with step 9 on page 13.

 

 

1/8”

(4)1/4”- 20 x 7/8” self drilling screws

1/8”

Pull Rope

NO. 6 SCREW EYE

 

Tools Needed:

WARNING

 

Power Drill

DO NOT INSTALL PULL ROPES

 

 

ON DOORS WITH ELECTRIC

 

1/8” Drill Bit

OPERATORS. CHILDREN MAY

 

 

BECOME ENTANGLED IN THE

 

 

ROPE CAUSING SEVERE OR FATAL

 

 

INJURY.

 

 

Measure and mark the jamb

PULL ROPE

 

 

 

approximately 48” to 50” (1220 to 1270

 

 

mm) from floor on the right or left side of

 

 

door. Drill 1/8” pilot hole for No. 6 screw

 

 

eye. Install the No. 6 screw eye. Tie the

BOTTOM BRACKET

 

pull rope to the No. 6 screw eye and to

PULL ROPE

 

the bottom bracket as shown.

 

 

22

 

 

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Image 22
Contents Aluminum Full View Table of Contents Package Contents Package Contents Door Section IdentificationTools Required P1 Removing An Old DoorFailure to Preparing the OpeningSecurely attach a Suitable mounting pad to structurallyInstallation Consult your Wayne-Dalton representative Tools NeededTo Bottom Brackets Bottom Section Installing Bottom Section HingesStacking Sections Section Inch trackTop Bracket Lift HandleStep Plate Top SectionAdjusting Top Brackets FlagangleTorsion End Bearing Brackets Center Bearing BracketTorsion Spring Assembly Attaching Torsion Springs to Center Bearing Bracket Securing Door Counterbalance CablesFor Spring Winding Winding Torsion Springs Parallel and within 3/4 Maximum of door edge Rear SupportKeep horizontal track Otherwise door could fallSet screws in the winding cone Tools Needed To adjust spring tension, fully closeThird roller. Insert a winding bar into AgencySide Lock Pull RopeTrolley Operator Both sides of the door section Exhaust Port InstallationOr a double wide bottom rail Outside Trim Ring #10 Hex Nuts GasketCleaning Cleaning Your Garage DoorLimited Warranty Model Thank you for your purchase