Wayne-Dalton 8850 Installation, Consult your Wayne-Dalton representative Tools Needed

	Preparing the Opening	Note: For other drums, mounting conditions, lifts, and options,
	Continued	consult your Wayne-Dalton representative.
Tools Needed:		HEADROOM CHART For Standard Lift Track (Minimum Distance Required)
	Wallangle	DRUMS	DIMS	3” TRACK, 15”	2” TRACK, 15”	2” TRACK,
	weather (angle mount)			RADIUS	RADIUS	12” RADIUS
	seal	400-8	HEADROOM	15-1/2”	14-1/2”	12-1/2”
			BACKROOM CHART & SIDEROOM CHART
	Used for Continuous wall angle track		TRACK	DEPTH
			SIZE	INTO ROOM	SIDEROOM
				DOOR HEIGHT
			2”	PLUS 18”	4”
	weather			IF TROLLEY
	seal			PLUS 66”
				DOOR HEIGHT
			3”	PLUS 24”	5-1/2”
	jamb 1/8” to 1/4”			IF TROLLEY
				PLUS 66”

Used for bracket mount track

FLUSH

FLUSH

1/2”- 5/8”

1/2”- 5/8”

MIN.1/2”-5 ROOMSIDE

5/16 X 1-5/8”

MIN.4” ROOMSIDE

5/16 X 1-5/8”

LAG SCREW

1”

LAG SCREW

1-1/2”

2” X 6” JAMB

2” X 6” JAMB IS

4-15/16”

4-3/16”

IS RECOMMENDED

RECOMMENDED

WOOD JAMBS

WOOD JAMBS

3” TRACK

2” TRACK

Installation

Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb and level with header.

Important: STAINLESS STEEL OR PT 2000 COATED LAG SCREWS (NOT SUPPLIED) MUST be USED When INSTALLING CENTER bearing brackets, END brackets, jamb brackets, OPERATOR MOUNTING/SUPPORT brackets AND DISCONNECT brackets ON TREATED Lumber (PRESERVATIVE-TREATED). STAINLESS STEEL OR PT 2000 COATED LAG SCREWS ARE NOT NECESSARY When INSTALLING PRODUCTS ON UN-TREATED Lumber.

Important: when installing 5/16” diameter lag screws using an electric drill/driver, the drill/driver’s clutch must be set to deliver no more than 200 In. lbs. Of torque. Fastener failure could occur at a higher setting.

Note: It is recommended that 5/16” lag screws be pilot drilled using a 3/16” drill bit, prior to fastening.

7

PRE-INSTALLATION

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com