Trolley Operator

�		Trolley Operator



Tools Needed:		WARNING

Tape Measure
		OPERATOR MUST BE TESTED

		AT TIME OF INSTALLATION AND
		MONTHLY THEREAFTER TO
		ENSURE THAT DOOR REVERSES
		ON CONTACT WITH 2 X 4 BOARD
		LAID FLAT UNDER THE DOOR.
		FAILURE TO ADJUST OPERATOR,
		IF NECESSARY, CAN RESULT IN
		SEVERE OR FATAL INJURY. IF YOUR
		OPERATOR IS EQUIPPED WITH A
		PHOTOELECTRIC EYE SYSTEM,
		THEN THIS MUST BE TESTED
		AT THE SAME TIME TO ENSURE
		THAT DOOR DOES NOT CLOSE
		AND A CLOSING DOOR OPENS IF
		PHOTOELECTRIC EYE SYSTEM IS
		OBSTRUCTED. FAILURE TO MAKE
		ADJUSTMENTS, IF NECESSARY,
		CAN RESULT IN SEVERE OR FATAL
		INJURY.
		1. Install operator rail 1/2” to 1-1/2”
		(13 - 38 mm) above high arc of top
		section of the door.
		2. Mount operator to ceiling so that
		1” to 1-1/2” (25 - 38 mm)
		clearance is maintained between
		trolley rail and top section when
		door is fully open (trolley rail will
		slope down towards rear).
		3. Attach door arm to operator bracket
		4. Attach operator rail to suitable
		mounting surface, 2 x 6 lumber
		minimum.
		5. Attach operator to ceiling using
		perforated angle.
		IMPORTANT: Angles must be
		securely attached to sound
		framing member(s).

OPERATOR RAIL

HEADER

perforated

OPERATORangle rail

OPERATOR

FRAMING MEMBERS

PERFORATED ANGLE

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com