Woods Equipment MDO80-2 manual Dealer Check Lists, PRE-DELIVERY Check List, Delivery Check List

DEALER CHECK LISTS

PRE-DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

Inspect cutter thoroughly after assembly to be certain it is set up properly before delivering it to customer. The following check list is a reminder of points to inspect. Check off each item as it is found satisfactory, correc- tions made or services performed.

___ Check all bolts to be sure they are tight.

___ Check that all cotter pins are properly installed and secured.

___ On pull-type cutter, make sure pin to prevent crank detachment is installed.

___ Check that PTO shaft is properly installed.

NOTICE

■Gearbox was not filled at factory. It must be serviced before operating cutter. (See page 18.) Failure to service will result in damage to gearbox.

___ Check that gearbox is properly serviced and seals are not leaking.

___ Lubricate cutter.

___ Check that blades have been properly installed.

DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

___	Show customer how to make adjustments.
___	Explain importance of lubrication to customer and
	point out lubrication points on cutter.
___	Point out safety features and options.
___	For mounted units, add wheel weights, ballast in
	front tires, and/or front tractor weight to enhance
	front end stability. A minimum 20% of tractor and
	equipment gross weight must be on front tractor
	wheels. When adding weight to attain 20% of
	tractor and equipment weight on front tractor
	wheels, you must not exceed the ROPS weight
	certification. Weigh the tractor and equipment. Do
	not estimate!
___	Give Operator's Manual to customer and recom-
	mend that customer become familiar with all sec-
	tions, especially the safety information.
___	Explain to customer that when transporting cutter
	on road or highway, day or night, safety devices
	should be used to provide adequate warning to
	operators of other vehicle.

15916 (Rev. 3/30/2007) Dealer Check Lists 35