Adjusting each channel level with test tone
•The volume level of each channel can be adjusted easily with the test tone function. Note: When speakers are switched off , the test tone function does not work.
Enter the test tone mode.
1
•The test tone will be heard from the speaker of each channel for 2 seconds as follows:
| FL | FC | FR | SR |
|
|
|
|
|
|
|
|
| ||||
| Front Left | Center | Front Right | Surround Right |
|
| ||
| SUB | SL ( | SC) | or ( |
| B L | BR) |
|
|
|
| ||||||
SUBwoofer | Surround Left (Surround Center) | (Surr. Back Left | Surr. Back Right) |
•Depending on the speaker setting(None or No), the test tone of the corresponding channel is not available.
•( ): possible depending on whether the surround back channel is set to 2 CH or 1 CH.
ENGLISH
At each channel, adjust the level as desired
2 until the sound level of each speaker is heard to be equally loud.
or
DOWNUP
•You can select the desired channel and adjust its
level with repeating the steps and in
“Adjusting the current channel levels” procedure.
Cancel the test tone function.
3
Adjusting the current channel levels
•After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes.
•If you have performed the CH LEVEL SETUP procedure on the OSD menu, you can memorize the adjusted channel levels into preset memory(PRESET 1, PRESET 2) and recall the memorized whenever you want. (Refer to “SETTING THE CH LEVEL SETUP” on page 66.)
Select the desired channel.
1
or
•Each time this button is pressed, the corresponding
channel is selected as follows:
SUBWOOFER
•Depending on the speaker settings and surround mode, etc., some channels cannot be selected.
•( ): possible depending on whether the surround back channel is set to 2 CH or 1 CH.
Note: When speakers are switched off, only
37