Programming a macro function | 2 | While “M1” is displayed, press the | |||
CURSOR UP( )/DOWN( ) buttons to | |||||
• The macro function enables you to program a series | |||||
select the MACRO button to be programmed | |||||
of button operations(up to 15) on this remote control |
| into, then press the ENTER button. | |||
into a single button. |
|
|
| ||
• You can store up to three separate macro command |
|
|
| ||
sequences into “M1”, “M2” and “M3” buttons. |
|
|
| ||
1 | Perform the steps and in “Entering a |
|
|
| |
setup code” procedure on page 19 to select |
|
|
| ||
the macro mode (“MACRO”). |
|
|
| ||
• Then “M1” is displayed on the LCD screen for | • Each time the CURSOR UP( )/DOWN( | ) buttons | |||
several seconds. | are pressed, “M1”, “M2” or “M3” is selected. | ||||
• During macro setting operation, pressing any of the | • Then “SEL” is flickering. |
| |||
DEVICE buttons cannot exit from the macro mode. | • If “SEL” goes off, start again from the above step . | ||||
3 | While “SEL” is flickering, press the | 4 | Press any of the MACRO buttons | ||
order.operation buttons you want to program in | (M1~M3) to complete the programming. | ||||
Example) When playing a DVD on the DVD player |
|
|
| ||
| connected to VIDEO 2 jacks of this receiver. |
|
|
| |
1. Press “AUDIO” button to control this receiver. |
|
|
| ||
2. Press “POWER ON” button to turn this receiver on. |
|
|
| ||
3. Press “VIDEO 2(7)” button to select the desired |
|
|
| ||
input source. |
|
|
| ||
4. Press “DVD” button to control the DVD player. |
|
|
| ||
5. Press “POWER ON” button to turn the DVD player | • Then “OK” is displayed. |
| |||
on. |
|
|
|
| |
6. Press “PLAY ( )” button to start playback. | To erase a macro program |
| |||
|
| • When erasing a macro program, perform the above | |||
|
| steps | , and , but ignore the step . |
| |
|
| To change a macro program |
| ||
• Each time the operation buttons are pressed, the | • When a new macro program is stored into a MACRO | ||||
button with performing the above steps | to , the | ||||
programmed order is displayed. | |||||
previous macro program is erased from the memory | |||||
|
| ||||
|
| of the MACRO button. |
|
ENGLISH
Operating a macro function
•Aim the remote control at the REMOTE SENSORs of the components to be controlled and press the MACRO button you want.
Example) When pressing “M1” button.
Notes:
•The codes programmed into a MACRO button will be transmitted at an interval of 0.5 seconds. However, some components may not be able to complete one operation in 0.5 seconds and may miss the next code. In this case, the macro function cannot control the corresponding components correctly.
•Be sure to use the remote control within the remote control operation range of the components.
•Depending on the operation status of the components, etc., the macro function cannot control the corresponding components correctly.
23