Sherwood R-865 manual Programing a punch-throughfunction, English

ENGLISH

Programing a punch-through function

•The punch-through function allows the volume controls , channel controls or transport controls to link to a different device while a device is controlled with this remote control as a master device.

•For example, since this receiver will likely be used as the sound system while watching TV, you may want to use volume controls to operate this receiver although this remote control is set to control the TV.

Perform the steps and in “Entering a

1 setup code” procedure on page 19 to select a master device and the punch -through mode (“PUNCH”).

•Then “VOL” is displayed on the LCD screen for several seconds.

While the device is displayed, press the

3 CURSOR UP()/DOWN() buttons to select the desired punch-through device, then press the ENTER button.

•Each time the CURSOR UP()/DOWN() buttons are pressed , depending on the selected punch- through mode, punch-through devices and the one punch-through deleting mode (“DELETE”) are selected as follows :

•In case of the volume punch-through,

AUDIO DELETE TV

•In case of the transport punch-through,

CD DELETE DVD VCR AUX

•In case of the channel punch-through,

TV DELETE SAT CABLE VCR

•Then “OK” is displayed and the current punch- through mode is displayed.

While “VOL” is displayed, press the

2 CURSOR UP()/DOWN() buttons to select the desired punch-through mode , then press the ENTER button.

•Each time the CURSOR UP( )/DOWN() buttons are pressed, the mode changes as follows:

VOL : The volume punch -through mode allows the “VOLUME / ” and “MUTE” buttons to function to operate a different device.

DELETE : All punch-through deleting mode.

PLAY : The transport punch-through mode allows the “”, “”, “ ”, “ ”, “ ”, “”, “” and “” buttons to function to operate a different device.

CH : The channel punch-through mode allows the “CH/ADJUST /” and “CH. SEL” buttons to function to operate a different device.

•Then the device to which you can link the selected punch-through mode is displayed.

While the punch-through mode is

4 displayed, repeat the above steps and to program other punch-through function under the same master device mode.

To program punch-through functions under

5 other master device mode, repeat the above steps to .

24