Sherwood R-865 Connecting Microphone, Connecting Pc For Upgrades, SWITCHED AC OUTLETs, Ac Inlet

11. CONNECTING MICROPHONE

•To use Auto Speaker Setup function, connect the supplied microphone to the SETUP MIC jack.(For details, refer to “When selecting the AUTO SPEAKER SETUP” on page 55.)

Notes:

•Because the microphone for Auto Speaker Setup is designed for use with this receiver, do not use a microphone other than the one supplied with this receiver.

•After you have completed the auto speaker setup procedure, disconnect the microphone.

Microphone

ENGLISH

12. CONNECTING PC FOR UPGRADES

•This receiver incorporates RS-232C terminal that may be used in the future to update the operating software so that it will be able to support new digital audio formats, external

control by using an external device and the like. PC with RS-232C port

• Connect RS-232C terminal to your PC.

Notes :

• Be sure to set the UPGRADE switch to “SVC” (service) UPGRADE switch

before updating.

•This switch should be set to “OPR” (operation) during normal operation except for upgrades.

If not, this receiver will not operate normally.

•Programming for upgrades and external control requires specialized programming knowledge and for that reason we recommend that it only be done by qualified installers. For more information on future upgrades and external control, visit the Sherwood web site at www.sherwoodamerica.com or contact your dealer.

•Do not disconnect the connection cable while updating the operating software, etc. Should this happen, it may be result in malfunction or cause damage to the unit.

13. SWITCHED AC OUTLETs

•Theses outlets are switched on(power-on mode) and off(standby mode) according to power control as

follows(Maximum total capacity is 100 W, 1 A).

Standby mode - Switched AC outlet off

Power-on mode - Switched AC outlet on

14. AC INLET

•Plug the supplied AC input cord into this AC INLET and then into the wall AC outlet.

Note:

•Do not use an AC input cord other than the one supplied with this unit. The AC input cord supplied is designed for use with this unit and should not be used with any other device.

To a wall AC outlet.

13