Sherwood R-865 manual Connecting Multi-Roomsystem Kit, ROOM 2 connections, English

ENGLISH

ROOM 2 connections

•ROOM 2 playback feature allows you to play a different program source in another room as well as one source in the main room at the same time.

•For ROOM 2 playback, connect the VIDEO 2 / ROOM 2 OUT jacks to the amplifier, TV, etc. installed in another room, or connect the SURROUND BACK speaker terminals to the speakers.

•In case of using a pair of speakers only, you should assign the power amplifier for surround back channels to the ROOM 2.(For details, refer to “SELECTING THE POWER AMP ASSIGN” on page 49.)

Notes :

•To minimize hum or noise, use high quality connected cords.

•You cannot use the digital audio signal for ROOM 2 playback.

Main room Another room(Room 2)

•When connecting VIDEO 2/ROOM 2 OUTs to the components.

This receiver

ININ

S-VIDEO VIDEO (COMPOSITE)

TV or projector

L AUDIO

R IN

AmplifierSpeakers

•When connecting SURROUND BACK speaker terminals to the speakers.

This receiver

Speakers

left right

10. CONNECTING MULTI-ROOM SYSTEM KIT

•The multi-room system kit (sold separately ) is essential for operation from a remote location.

For information on the multi-room kit, contact the Xantech corporation at 1-800-843-5465 or www.xantech.com.

•IR IN jack allows you to control this receiver from another room with the remote control unit.

•To control this receiver from another room with the remote control unit, connect the IR IN jack to the output of the connecting block.

•If this receiver is located inside a cabinet or other enclosure where the infrared beams from the remote control unit cannot enter, then operation with the remote control unit will not be possible.

In such a case, connect the IR IN jack to the output of the connecting block.

Note:

•Remote operation may become unreliable if the IR receiver is exposed to strong light such as direct sunlight or inverted fluorescent.

Main room

This receiver

Connecting block (Multi-room system kit)

output

Another room(Room 2)

IR receiver (Multi-room system kit)

•When this receiver is located inside a cabinet.

In the cabinet

This receiver

output
Connecting block	IR receiver
(Multi-room system kit)	(Multi-room system kit)

12