Sherwood R-865 Erasing the programmed command, from one button, Erasing all the commands, English

ENGLISH

Erasing the programmed command		While “BTTN” is displayed, press the
		CURSOR UP(	)/DOWN( ) buttons to
from one button
		2 select the one command deleting mode
	Perform the steps and in “Entering a	(BTTN), then press the ENTER button.
1
	setup code” procedure on page 19 to select
	the delecting mode (“DELETE”).

•Then “BTTN” is displayed on the LCD screen for

several seconds.

While “SEL” is flickering, press the button
3 for the command you want to erase.	• Each time the CURSOR UP( )/DOWN( ) buttons
Example) When the button for the command to be	are pressed, “BTTN” or “LEARN”(all command
erased is PLAY button	deleting mode) is selected.
	• Then “SEL” is flickering.
	• If “BTTN” goes off, start again from the above step .
	While “SEL” is flickering, repeat the above
	4 step to erase other commands.

•“OK” is displayed and then “SEL” is flickering.

Erasing all the commands		2	While “BTTN” is displayed, press the
			CURSOR UP( )/DOWN( ) buttons to
programmed under a device mode
			select the all command deleting mode
	Perform the steps and in “Entering a		(“LEARN”), then press the ENTER button.
1
	setup code” procedure on page 19 to select
	the deleting mode (“DELETE”).

• Then “BTTN” is displayed on the LCD screen for several seconds.

While “SURE?” is displayed, press the 3 ENTER button

• Then “SURE?” is displayed .

• If “SURE?” goes off, start again from the above step

To erase all the commands programmed

4 under other device mode, repeat the above steps to .

•Then all the commands programmed are erased.

22