Programing the commands from other | Press and hold down the ENTER button | |
and the desired one of the DEVICE buttons | ||
remote controls( LEARNING mode ) | ||
2 for more than 2 seconds. | ||
|
• If the setup codes are not available for your component or you want to program a missing or special function into one button of a device, the learning function enables this remote control to learn the commands from other remote controls.
Place this remote control and other remote
1 control facing each other at a distance of 5 to 15 cm (2 to 6 inches ) apart.
|
| • Then “LEARN” is displayed on the LCD screen for | |
|
| several seconds | |
|
| Note : |
|
| 5 to 15 cm | • During setting operation , to exit from the setting | |
| (2 to 6 inches) | mode, press any of the DIVICE buttons. | |
3 | While “LEARN” is displayed, press the | 4 | While “SEL” is flickering, on this remote |
ENTER button. | control, press the button corresponding to | ||
| the function to be learned. | ||
|
| Example) If the function to be learned is playback, | |
|
|
| press the PLAY( ) button. |
• Then “SEL” is flickering. |
|
|
|
| ||
|
|
|
| |||
• If “SEL” goes off, start again from the above step . |
|
|
|
| ||
• Then “READY” is displayed. | ||||||
|
| |||||
|
| Note: |
|
|
| |
|
| • You cannot program a function into some buttons | ||||
|
| such as DEVICE, MACRO and LIGHT buttons. | ||||
|
|
|
|
|
| |
5 | While “READY” is displayed, on the other | 6 | While “SEL” is flickering, repeat the above | |||
remote control, press the button of the | steps and to program all the | |||||
function to be learned. | commands you want to the buttons on this | |||||
|
|
| remote control under the same device mode. | |||
• If the command has been learned successfully, | To exit from the setting mode, press any of the | |||||
“OK” is displayed and then “SEL” is flickering. | ||||||
• If “ERROR” is displayed and then “SEL” is | DEVICE buttons. | |||||
flickering, it means that for some reason the |
|
|
|
| ||
|
|
|
| |||
command was not learned. In this case, repeat the |
| Repeat the above steps to to program | ||||
above steps and . | 7 | |||||
the commands from a different remote | ||||||
Notes : |
| control. | ||||
|
|
|
|
| ||
• If an incorrect signal has been sent or, in some |
|
|
|
| ||
|
|
|
| |||
cases, the command from other remote control | 8 | Operate the newly programmed buttons to | ||||
simply cannot be learned. | ||||||
make sure the learning function was | ||||||
• In some “ERROR” cases, the remote controls just | ||||||
performed properly. | ||||||
need to be moved closer together or farther apart. | ||||||
|
|
|
|
ENGLISH
21