Sherwood R-865 Operating a punch-throughfunction, Erasing the programmed puch-throughfunction

Operating a punch-through function

•While this remote control is set to control a master device, aim the remote control at the REMOTE SENSOR of the punch-through device and press the desired button of the programmed punch-through controls.

Example ) When pressing “PLAY ()” button.

•Then the punch-through device is displayed on the LCD screen.

ENGLISH

Erasing the programmed puch-through function

Perform the steps and in “Entering a

1 setup code” procedure on page 19 to select a master device and the punch-through mode (“PUNCH”).

•Then “VOL” is displayed on the LCD screen for several seconds.

While the device is displayed, press the

3 CURSOR UP()/DOWN( ) buttons to select the one punch-through deleting mode(“DELETE”), then press the ENTER button.

•Each time the CURSOR UP()/DOWN() buttons are pressed, depending on the selected punch- through mode, the punch-through devices and the deleting mode (“DELETE”) are selected.

•Then “OK” is displayed and the current punch- through mode is displayed .

While “VOL” is displayed, press the

2 CURSOR UP()/DOWN() buttons to select the punch-through mode to be erased, then press the ENTER button.

•Each time the CURSOR UP()/DOWN() buttons are pressed, the mode changes as follows:

VOL DELETE PLAY CH

•Then the device is displayed .

While the punch-through mode is

4 displayed, repeat the above steps and

to erase other punch-through function under the same master device mode.

To erase punch-through functions under

5 other master device mode, repeat the above steps to .

25