Sherwood R-865 manual English, Adjust the level of the selected channel as

ENGLISH

Adjust the level of the selected channel as

2 desired.

or

DOWNUP

3	Repeat the above steps	and	to adjust
	each channel level.

Adjusting the Dolby Pro Logic IIx / Dolby Pro Logic II Music parameters

•When selecting either the Dolby Pro Logic IIx Music mode or the Dolby Pro Logic II Music mode depending on whether “S/B CH” is set to “None” or not, you can adjust the various surround parameters for optimum surround effect.(Refer to “When selecting the SPEAKER CONFIGURATION” on page 49.)

•In case of PL IIx MUSIC mode, only when original surround mode is “BYPASS” mode or 2 channel digital signals from Dolby Digital sources, etc. are input, these parameter settings affect the surround effects.

Press the DOLBY PL II MUSIC PARAMETER button to select the desired parameter.

1		• Each time this button is pressed, the parameter changes
		and is displayed for several seconds as follows;
		Panorama mode(“PANORAMA”, default value : OFF)
		This mode extends the front stereo image to include
		the surround speakers for an exciting “wraparound”
		effect with side wall imaging. Select “OFF” or “ON”.
	or	Center width control(“C-WIDTH”, default value : 0)
		This adjusts the center image so it may be heard only
		from the center speaker, only from the left/right
		speakers as a phantom image, or from all three front
		speakers to varying degrees.
		The control can be set in 8 steps from 0 to 7.
		Dimension control(“DIMENSION”, default value : 0)
		This gradually adjusts the soundfield either towards
		the front or towards the rear. The control can be set
		in 7 steps from -3 to +3.

At the desired parameter, adjust it as desired.

2

or

DOWNUP

•If the parameter display disappears, start from the step again.

3	Repeat the above steps	and	to
	adjust other parameters.

38