Sherwood R-865 manual When selecting the DC Trigger Setup, When the DC Trigger mode is set to On

When selecting the DC TRIGGER SETUP

•To turn on the component connected to DC TRIGGER OUT jack when the desired input source is selected, you should link DC TRIGGER with the desired input source.

Press the CURSOR UP( )/DOWN() buttons to select the DC TRIGGER, then press the ENTER

1 button.

D C T R I G GE R S E T U P
D C T R I G GE R	:	Off
T U N E R	V I D E O 1
C D	V I D E O		2
A U X	V I D E O		3
T A P E MON .	V I D E O		4
E N T E R : S e t	, , ,	: M o v e

ENGLISH

Press the CURSOR LEFT( )/RIGHT()

2 buttons to select the DC TRIGGER mode as desired.

•Each time these buttons are pressed, the DC TRIGGER mode changes as follows:

On : Select this to activate the DC trigger function.

Off : Select this to cancel the DC trigger function.

When the DC TRIGGER mode is set to On

Press the CURSOR UP()/

3 DOWN()/LEFT()/RIGHT( ) buttons to select the desired input source that uses the DC trigger function, then press the ENTER button.

•Each time the CURSOR CONTROL buttons are

pressed, “” is moved to the corresponding input source.

When the ENTER button is pressed at the desired input source, “+” is marked it with.

•When the input sources marked with “+” on this menu are selected with the AUDIO and VIDEO SELECTOR buttons, etc.,the DC trigger function is automatically activated. (For details, refer to “CONNECTING DC TRIGGER OUT” on page 9.)

•When the ENTER button is pressed at the input source marked with “+”, “+” is cleared and the DC trigger function is canceled for this input source.

•Repeat this step until the desired input sources are all selected.

61