Sherwood R-865 manual Entering a label, Correcting or clearing a label

Entering a label	2	Press the LABEL button to enter the label
		input mode.
• This function can be operated on the input sources		Example ) When selecting VIDEO 1.
except TUNER, TAPE MONITOR and 8 CH
DIRECT.
Select the desired input source to enter its
1 label.
or	4	Confirm your selection.

			• Then the next digit will flicker.
3	Select the character on the flickering digit.
			5	Repeat the above steps	and to enter
				the desired characters on the rest of the
				digits.
			• On up to 9 digits, the desired characters can be entered.
• Each time the MULTI CONTROL knob is rotated,			Note: If any of INPUT SELECTOR buttons is
				pressed while entering a label, the label input
the characters change as follows:
				mode will be canceled.
Blank (		)
Alphabets: A~Z, a~z			6	Memorize the desired label.
Numerals: 0~9
Symbols:
Correcting or clearing a label			2	Repeat the steps ~	in “Entering a
				label” procedure.
1	Select the desired input source to be
	rectified or cleared.
			• To clear a label, make a blank on each digit and
			memorize it, then the label is cleared and its factory
		or	input source will be displayed.
			• If the LABEL button is pressed for more than 3
			seconds, blanks will be made on all the digits at
			once.

ENGLISH

45