Remove the two rear carriage bolts from the left side skid. Place baffle (1) under cutter frame and attach as shown in Figure 21.
3
2 1
4
6
5 | 6 |
| |
| 7 |
| CD3819 |
1.Distribution baffle
2.1/2 x 1" Bolt
3.1/2" Flanged hex lock nut
4.5/8 x 2" Carriage bolt
5.3/4" Flat washer
6.5/8" Flat washer
7.5/8" Nut
Figure 21. Distribution Baffle Installation
Gearbox Lubrication
NOTICE
■The gearbox was not filled at the factory. It must be serviced before operating cutter. Failure to service will result in damage to the gearbox.
Chain Shielding Installation
DANGER
Full chain shielding, designed to reduce the possibility of thrown objects, must be installed when operating in populated areas or other areas where thrown objects could injure people or dam- age property. If this machine is not equipped with full chain shielding, operation must be stopped when anyone comes within 300 feet.
All four chain assemblies (1) are interchangeable. Place each assembly on the cutter and attach by inserting bolt (4) up through the cutter and chain shield assembly, then install flange lock nut (5) on each bolt.
The threaded rods (2) are sold separately. To install, place a lock nut (3) on one end and thread rod (2) through bottom of 16 chain links, then secure with another lock nut (3). Two rods (2) are used on each chain shield assembly (1).
Figure 22. Chain Shielding Assembly
15914 (Rev. 5/11/2007) | Assembly 29 |
|
|