Woods Equipment Tongue Installation for D80-2 Pull-Type Cutter, Tongue and H-Frame Assembly

1.	Tongue	28
		10	11
2.	Tongue lug
		29

3.Tongue adjustment bracket

4.Compression member

5.	H-Frame					30
6.	Mast plate
7.	Compression bracket					32
8.	Rear U-joint shield
9.	Carrier bearing housing				9	8
10.	Drive shaft shield
11.	Clamp bolt			32
12.	5/8 x 2-1/4" Bolt
13.	5/8" Flat washer
14.	5/8 x 7/8 x 11/16" Bushing		23	24		28
15.	5/8" Lock washer
				25
					17
16.	5/8" Hex nut
		17		20		7
17.	3/16 x 1" Cotter pin
						31
18.	5/8 x 6-3/4" Clevis pin			21	20
		22
	27			6
			5			26
		4			21
				16
		20		15		14
	21			2		13
						12
				1
		3
				18
				17	CD3823A
				19
19. 1/2 x 1-3/4" Bolt				24. 1/2" Schedule 40 x 3-9/16"		28. 3/8 x 1" Bolt
20. 1/2" Heavy lock washer				pipe		29. 3/8" Lock washer
21. 1/2" Heavy hex nut				25. 1/2 x 2" Clevis pin		30. 1/4 x 3" Cotter pin
22. 1/2 x 5-1/2" Clevis pin				26. 1/2 x 1-1/4" Bolt		31. 3/8" Flanged lock nut
23. 1/2 x 5-1/2" Bolt				27. Parking jack		32. Tether chain

Figure 24. Tongue and H-Frame Assembly

Tongue Installation for D80-2 Pull-Type Cutter

Attach compression bracket (7) to front of gearbox stand with lock washers (20) and nuts (21), see Figure 24.

Align holes in tongue (1) to bottom hole of mast plate

(6)and insert bushing (14) through the holes, then place washer (13) on bolt (12) and insert through mast plate, bushing and tongue. Install lock washer (15) over bolt and attach with nut (16).

Support tongue by attaching jack (27).

Attach compression member (4) to compression bracket (7) with clevis pin (25) and cotter pin (17), then attach front end to tongue with bolt (19), lock washer

(20)and nut (21). The compression member setting must be adjusted when the cutting height is set.

Align H-frame (5) to tongue (1) and attach with clevis pin (18) and two cotter pins (17).

Place key in gearbox input shaft, loosen clamp bolt (11) on rear of driveline, and slide driveline onto gearbox input shaft. Tighten clamp bolt and install cotter pin (30) through driveline and input shaft. Snap rear tether

15914 (Rev. 5/11/2007) Assembly 31