Woods Equipment MD80-2 manual Optional Hydraulic Installation for D80-2 Pull-Type Cutter

chain (32) around the compression link to prevent driv- eline shield rotation.

Align driveline in H-frame and insert clevis pin (22) through H-frame and carrier bearing (9). Attach by inserting two cotter pins (17) in clevis pin (22). Snap middle tether chain (32) around H-frame to prevent driveline shield rotation.

Attach rear universal joint shield (8) to gear stand as shown with bolts (28) and nuts (31). Place forward driv- eline shield (10) over H-frame and attach with lock washer (29) and bolt (28).

Attach pipe (24) to H-frame using bolt (23), lock washer

(20)and nut (21). Attach front tether chain (32) securely to tractor.

Optional Hydraulic Installation for D80-2 Pull-Type Cutter

Remove the crank (7) from pivot link holder (6), insert pivot link (5) into pivot link holder (6), then install the crank and cotter pin (8), see Figure 25.

Remove bolt (2) from H-frame, install hydraulic hose holder (3), and install bolt.

Install hydraulic cylinder (9) using clevis pins (11), then route hose through hose holder (3).

1.	Pivot link kit	7.	Crank
2.	1/2 x 5-1/2" Bolt	8.	1/4 x 1-1/2" Cotter pin
3.	Hose holder	9.	Cylinder
4.	1/2" Hex nut	10.	H-Frame
5.	Pivot link	11.	Clevis pin
6.	Pivot link holder	12.	Pivot nut

Figure 25. Optional Hydraulic Lift Assembly

32 Assembly 15914 (Rev. 5/11/2007)