Splitter Gearbox Inspection | 4. Install breather (24) in top cover. | |
1. | Check gearbox for leaks by: plugging all holes |
|
| except one, applying 4 psi of compressed air, and | Splitter Gearbox Installation |
| immersing gearbox in water. Verify gearbox does |
|
| not leak. | NOTE: Gearbox is heavy: do not attempt to move with- |
| NOTE: Excessive air pressure will damage seals. | out mechanical assistance. |
2. | Remove gearbox from water and dry off. | Use loctite when mounting gearbox. Set gearbox on |
|
| |
3. | Remove upper plug on right side of housing. Add | cutter and fasten with bolts and nuts. Torque bolts to |
| SAE 80W or 90W EP oil until it runs out side level | 170 |
hole. Replace plug.
2. 10 mm Lock washer
3. M10 x 1.5P x 30 HHCS
4. Input cap
5. Input shaft
6. Input oil seal
7. Bearing assembly (cup & cone)
8. Gasket .15 mm
9. Gasket .25 mm
10. Gasket .40 mm
11. Hub cap
12. Oil seal
13. Output shaft
14. Spacer
15. Shim .30 mm
16. Shim .40 mm
17. Shim .50 mm
18. Center gear
19. Wing gear
20. Bearing adjustment nut
21. 1/8 x
22. Sealing washer
23. M18 x 1.5P Level plug
24. M18 x 1.5P Breather plug
Figure 15. Splitter Gearbox - Style A
MAN0963 (2/16/2012) | Dealer Service 33 |
|
|