2.Place brace (2) inside the front corner of the weight box (1) and secure with two cap screws (10), two flat washers (12), and two lock nuts (14).
3.Align mounting plate (4) with slots of rear of weight box. Secure with two cap screws (10), two flat washers (12), and two lock nuts (14). Do not tighten hardware at this point.
4.Align skid shoe (3) with holes on bottom and inside of weight box. Secure bottom with the hardware provided with skid shoe. Secure top with two cap screws (10), two flat washers (12) and two lock nuts (14).
5.Place weight box assembly adjacent to the center section and align hinge sections.
6.Insert hinge pin through the hinge sections. Install sleeve (5) on hinge pin behind deck hinge section to prevent weight box from sliding rearward. Secure hinge pin with two washers (16) and two spring pins (9).
7.Insert clevis pin (7) through lug on rear of weight box and cylinder lug on center section with two washers (16) as shown. Secure with cotter pin (8).
8.Insert
Winch Kit Installation (Optional)
Refer to page 81 for Installation and Operation instruc- tions.
50 Assembly | MAN0963 (2/16/2012) |
|
|