Woods Equipment BW180XHDQ, BW126XHDQ manual Reinstallation on Cutter, Splitter Gearbox Style B

17.Check gear backlash, backlash should be between 0.006" and 0.016". You should not have to adjust for backlash.

18.Place seal (3) over shaft and press into housing using a tube of the same diameter. Seal should be flush with housing when properly installed. Repeat process for opposite end shaft. Splitter Gearbox Inspection

1.Place top cover (10) on housing and secure into position using six cap screws (11).

2.Check gearbox for leaks by: plugging all holes except one, applying 4 psi of compressed air, and immersing gearbox in water. Verify gearbox does not leak.

NOTE: Excessive air pressure will damage seals.

3.Remove gearbox from water and dry off.

4.Remove upper plug on right side of housing (oil level hole). Add SAE 80W or 90W EP oil until it runs out side level hole. Replace plug.

5.Install breather (12) in top cover.

Reinstallation on Cutter

NOTE: Gearbox is heavy: do not attempt to move it without mechanical assistance.

1.Place gearbox on cutter and secure into position using four cap screws and lock nuts.

2.Torque hardware to 175 lbs-ft.

3.Attach all drivelines to gearbox.

4.Install all shields.

1. Bearing

3.Oil seal

4.Snap ring

5.Shim

6.Pinion gear

7.Shaft 1-3/4, 20 spline, wing

8.Gear

9.Shaft 1-3/4, 20 spline, center

10.Cover

11.M10 x 30 Cap screw 8.8

12.1/2 Breather

Figure 16. Splitter Gearbox - Style B

MAN0963 (2/16/2012) Dealer Service 35