Woods Equipment BB72X, BB48X, BB84X, BB60X manual Be Careful, Crushing and Pinching Hazard

Page 11

SAFETY & INSTRUCTIONAL DECALS

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

Replace Immediately If Damaged!

WARNING

CRUSHING AND PINCHING HAZARD

Be extremely careful handling various parts of the machine. They are heavy and hands, fingers, feet, and other body parts could be crushed or pinched between tractor and implement.

Operate tractor controls from tractor seat only.

2 - 1006681

 

 

 

 

DANGER

 

 

 

 

 

 

If shaft connection is visible, shield

7 - PN 1004114

is missing. Replace shield before

operating equipment.

1004114

 

 

 

 

 

 

Do not stand between tractor and implement when tractor is in gear.

Make sure parking brake is engaged before going between tractor and implement.

Stand clear of machine while in operation or when it is being raised or lowered.

FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.

WARNING

TO AVOID SERIOUS INJURY OR DEATH:

Read Operator's Manual (available from dealer) and follow all safety precautions.

Keep all shields in place and in good condition. Operate mower from tractor seat only.

Lower mower, stop engine and remove key before dismounting tractor.

Allow no children or untrained persons to operate equipment. Do not transport towed or semi-mounted units over 20 mph.

FAILURE TO OPERATE SAFELY CAN

RESULT IN INJURY OR DEATH.

WARNING

10 - PN 33347

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿33347E

FALLING OFF CAN RESULT IN BEING RUN OVER.

Tractor must be equipped with ROPS (or ROPS CAB) and seat belt. Keep foldable ROPS systems in "locked up" position at all times.

Buckle Up! Keep seat belt securely fastened.

Allow no riders.

RAISED EQUIPMENT CAN DROP AND CRUSH.

Before working underneath, follow all instructions and safety rules in operator's manual and securely block up all corners of equipment with jack stands.

Securely blocking prevents equipment from dropping from hydraulic leakdown, hydraulic system failures or mechanical component failures.

FALLING OFF OR FAILING TO BLOCK SECURELY CAN RESULT IN SERIOUS INJURY OR DEATH.

WARNING

DO NOT EXCEED PTO SPEED OF

540 RPM

PTO speeds higher than 540 RPM can cause

equipment failure and personal injury.

1006681

BE CAREFUL!

Use a clean, damp cloth to clean safety decals.

Avoid spraying too close to decals when using a pressure washer; high-pressure water can enter through very small scratches or under edges of decals causing them to peel or come off.

Replacement safety decals can be ordered free from your Woods dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call 1-800-319-6637.

MAN0632 (5/15/2007)

Safety 11

 

 

Image 11
Contents Brushbulltm To the Owner IntroductionTo the Dealer Table of Contents BB48X BB60X BB72X BB84X SpecificationsGeneral Information Safety Free Mower Safety VideoWoods Equipment Company Training Package for Rotary Mowers/Cutters-EnglishTraining Package for Rotary Mowers/Cutters-English/Spanish Operation Safety RulesTraining PreparationMaintenance Storage RED Rear Reflector Safety & Instructional DecalsSerial Number Plate Crushing and Pinching Hazard Be CarefulAttaching Cutter to Tractor BB48X only OperationOperation Tractor StabilityQuick Hitch Attachment BB48X Only Top Link Adjustment BB48X OnlyAttaching Cutter to Tractor BB60X, BB72X, BB84X only Installation and Removal Driveline Tractor PTOShortening Driveline Driveline AttachmentShredding Material Cutting Height AdjustmentDriveline Interference Check PRE-OPERATION Check List Check Chain AdjustmentOperating Technique Lubrication Information Owner ServiceOwner Service Blocking MethodBlade Removal Figure Blade Installation FigureBlade Servicing Walterscheid BB84X Only Slip Clutch AdjustmentBlade Sharpening ComerModel WalterscheidShielding Repair Driveline Shear Bolt ReplacementCleaning Mowing Conditions TroubleshootingProblem Possible Cause Solution Seal Replacement Dealer ServiceDealer Service Gearbox MaintenanceGearbox Repair Seal RepairVertical Shaft Seal Repair Horizontal Seal Leak RepairReassemble Gearbox Reinstall GearboxBB48X, BB60X, BB72X BB72X S/N 1159929 and Above only On CAST/CROWN TOP BB48X, BB60XReassemble Gearbox Cast Top BB48X Reassemble Gearbox Cast Top BB60X and BB72X Crossbar Removal Crossbar RemovalUniversal Joint Repair Crossbar InstallationJoint Disassembly Install Cups Joint AssemblyDelivery Check List Dealer Check ListsDealer Check Lists PRE-DELIVERY Check ListDealer Check Lists Dealer SET-UP Instructions AssemblyAssembly Disassemble Shipping Unit Figure BB60X, BB72X & BB84X Shipping ConfigurationBB60X, BB72X & BB84X Install A-FRAMEInstall A-FRAME to Diagonal Brace Bars BB48XBB48X Quick Hitch Set-Up Install TailwheelInstall Dual Tailwheel BB84XD Optional BB48X Standard Hitch Set-UpDriveline Slip Clutch Optional on BB48X & BB60X Install DrivelineBB60X, BB72X & BB84X Standard & Quick Hitch Set-Up Shear Bolt Driveline BB48X & BB60X OnlyFill Gearbox Install Safety ShieldingDriveline Slip Clutch BB72X and BB84X Rubber Deflector StandardBB84X Install Optional Check ChainsBB60X BB72X Parts Parts Index BrushbulltmBB48X, BB60X, BB72X & BB84X BB84X Shown Brushbull STANDARD-DUTY Main AssemblyBB72X, BB84X BB48X, BB60X, BB72X & BB84X Main Assembly Parts ListGearbox repair asy BB72X S/N 1159928 and Below Gearbox Assembly Flat TOPBB48X Gearbox Assembly Parts ListCheck Chain Assembly Optional Gearbox Assembly CAST/CROWN TOP BB48X Comer Standard Driveline Assembly BB60X Comer Standard Driveline Assembly BB48X & BB60X Comer Slip Clutch Driveline Assembly Optional BB72X Comer Slip Clutch Driveline Assembly Series 50 Series BB84X Comer Slip Clutch Driveline AssemblyBB84X Walterscheid Slip Clutch Driveline Assembly Front Rubber Shielding Standard Front & Rear Chain Shielding OptionalMetric Series Bolt Torque ChartSAE Series Torque Chart AppendixAbbreviations Bolt Size ChartIndex IndexWarranty Rev /23/2005