Woods Equipment BB48X manual Attaching Cutter to Tractor BB60X, BB72X, BB84X only

BB60X

& BB72X

BB84X

Figure 4. Standard Hitch and Quick Hitch Configurations - BB60X, BB72X & BB84X

ATTACHING CUTTER TO TRACTOR - BB60X, BB72X, BB84X ONLY

Standard Hitch

1.Position tractor 3-point arms between the mast plates and secure with hitch pins and cotter pin. See left side of Figure 4. Note pin orientation for the BB84X.

2.Connect the tractor top link to the cutter A-frame using the upper holes and the appropriate hardware. The break link must be placed in the lower holes of the A-frame.

Quick Hitch

1.Position tractor 3-point arms between the mast plates and secure with hitch pins and cotter pin. See right side of Figure 4. Note pin orientation for the BB84X.

2.Attach tractor with the quick hitch to the cutter and secure according to the quick hitch manufacturer's instructions.

INSTALLATION AND REMOVAL

OF DRIVELINE (TRACTOR PTO)

To Install:

Pull locking collar back and at the same time push driv- eline onto tractor PTO shaft until locking device engages.

To Remove:

Hold driveline into position, pull locking collar back, and slide driveline off tractor PTO shaft.

Figure 5. Lock Collar

14 Operation MAN0632 (5/15/2007)