Metrologic Instruments MS7220 manual Installation for STAND-ALONE Keyboard Interface

INSTALLATION FOR STAND-ALONE KEYBOARD INTERFACE

1.Follow the “Getting Started” steps on page 3.

2.Turn of the host system.

3.Disconnect the keyboard from the host.

4.Connect the PowerLink cable to the jack labeled “Stand-Alone Keyboard” on the MS7220.

5.Connect the other end of the PowerLink cable to the keyboard port on the host.

Before continuing verify that the powerlink cable is connected to the proper communication jack on the scanner. Incorrect cable connection can cause communication problems or potential damage to the scanner.

6.Connect the external power supply to the power jack on the PowerLink cable.

7.Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet.

8.Connect AC power to the transformer. The outlet should be near the equipment and easily accessible.

9.Slide the cable cover into place on the back of the scanner then secure it with the three M3 screws provided.

10.Turn on the host system.

Stand-Alone

Keyboard

Figure 4: Stand-Alone Keyboard Interface

11. Scan the bar codes below to configure the MS7220 for Stand-Alone Keyboard communication.

Load Keyboard Wedge Defaults Enable Stand-Alone Keyboard

Scan 1st ³ 9 9 9 9 9 4

Scan 2nd ³ 5 1 5 5 1 5 3

Caution:

To maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.

To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the power source should meet applicable performance requirements for a limited power source.

8