North Star M268180M owner manual Proper Operation of the Spray Gun

Page 25

Operation - Using the Sprayer (continued)

6.Operate spray gun (as needed for application)

Proper Operation of the Spray Gun

Cone and Stream spray pattern instructions

1.Pull the choke back. Squeeze thetrigger to begin spraying.

2.The spray pattern is determined by how far the trigger is pulled back. The spray begins at a wide cone and progressively becomes a straight stream when the trigger is pulled all the way back.

3.Once the desired spray pattern is achieved, press the trigger lock to hold the position of thetrigger. To release thetrigger lock, pull the trigger back until the lock disengages.

4.When the gun is not in use, activate the safety lock by releasing the trigger and pressing the safety lock pin. This will lock thetrigger in the off position to prevent accidental spraying.

Additional orifice and

Trigger lock

spare O-ring storage

Safety lock

Choke pulled back

Fig 02364

Trigger

Swivel connection

Fog and Stream spray pattern instructions

1.Push the choke all the way forward.

2.Squeeze the trigger to begin spraying. Set thetrigger to a wide cone spray pattern. This will achievethe best atomized mist.

3.Pull the trigger all the way back to change to a straight stream.

Choke pushed forward

Fig. 02365

Note: Operating pressure of the pump will vary depending on the orifice size used. 110 psi is achieved with the small orifice. The medium and large orifices achieve 50 and 2 psi, respectively. (Additional orifices are located under the yellow plug on the top of the gun.)

IMPORTANT: ALWAYS hold the spray gun with a firm grip when spraying at higher pressures in order to prevent gun from whipping. Keep good footing and balance at alltimes.

Note: It is not unusual for the operator to be exposed to chemical drips while adjusting the spray pattern – gloves should be chemical resistant.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents M268180M Hazard Signal Word Definitions Table of Contents Spraying Pesticides Intended UseGeneral Chemical Safety Summary of Important Safety InformationChemical Application Safety ATV Vehicle Handling Safety Chemical Accident Procedures Unpacking Closely inspect all contents in the shipping cartonFollowing items are found in the manual bag Step One Attach gauge AssemblyStep Two Attach gun hose to spray gun and pump Step Three Attach gun clips to tankStep Six Attach sprayer to vehicle Step Five Attach hose guide to tankPreparatory safety Preparatory safety steps Step Seven Connect power cords to vehicle batteryPrepare wire ends Separate powerVehicle battery To install battery clampsTogether Attach remote switchCheck and test completed assembly Step Eight Check and test completed assemblyCheck assembly Working conditionMachine Components General Chemical Safety Operation Important Safety InformationBefore Spraying Chemical Application SafetyDuring Spraying After SprayingATV Vehicle Handling Safety To be automatically linked to the nearest certified poison InhalationOperation Preparing the Sprayer for Each Use Important safety rulesStep One Assess wind conditions and clear work area Operation Using the SprayerSpray because the wind is too strong Step Two Fill the sprayer Fill the sprayer using the following stepsEnsure tank is flushed of all chemicals from prior uses Fill tank Check drainTurn on power Review safetyStep Three Operate the sprayer Ensure flowOperate spray gun as needed for application Proper Operation of the Spray GunImmediately Open until desired amount of agitation is achievedDrain tank Step Four Clean sprayer and decontaminate after useDecontaminate LaunderPreparing for storage StorageRemoving from storage Before attempting to service the sprayer TroubleshootingAny Questions, Comments, Problems or Parts Orders SpecificationsPart# Description Exploded View 268180 Rev. M

M268180M specifications

The North Star M268180M is a robust and versatile utility vehicle designed to meet the demands of various industries, including agriculture, construction, and outdoor recreational activities. This model is recognized for its unique blend of power, efficiency, and durability, which make it an ideal option for users seeking a reliable companion for their demanding tasks.

One of the standout features of the M268180M is its powerful engine, which provides robust performance across a range of terrains. The vehicle is equipped with a high-efficiency diesel engine that ensures low fuel consumption while delivering substantial torque. This makes it not only economical to operate but also capable of tackling heavy loads and challenging landscapes with ease.

The M268180M boasts advanced off-road capabilities, thanks to its impressive four-wheel-drive system and superior suspension design. This enables the vehicle to navigate rough and uneven terrain without compromising on comfort or stability. The all-terrain tires provide excellent grip, ensuring that the M268180M can handle mud, sand, and rocky surfaces without difficulty.

In terms of technology, the North Star M268180M is equipped with a user-friendly dashboard that provides essential information at a glance, enhancing the driver's control over the vehicle. Additionally, it features advanced safety systems, including robust braking mechanisms and roll-over protection, ensuring that operators can work safely even in challenging conditions.

Comfort is another key aspect of the M268180M, which is designed with ergonomically crafted seating and ample cabin space. The interior accommodates the driver and passenger comfortably, allowing for long hours of use without fatigue. Furthermore, it offers easy access and excellent visibility, making navigation simple and intuitive.

Durability is paramount in the design of the M268180M, which features a rugged frame and reinforced body to withstand the pressures of heavy-duty use. Its materials are chosen to resist wear and tear, ensuring longevity and reliability in various operating environments.

In summary, the North Star M268180M stands out with its powerful engine, advanced off-road capabilities, user-friendly technology, comfort-focused design, and exceptional durability. This utility vehicle is an excellent choice for those seeking a dependable, high-performance machine to handle their most demanding tasks efficiently.
Top Page Image Contents