North Star M268180M owner manual Troubleshooting, Before attempting to service the sprayer

Page 29

Troubleshooting

WARNING

Before troubleshooting or attempting to service, read the following safety rules to avoid accidental exposure to chemical and also risk of electric shock.

Note: A reserve, clean container capable of holding at least 16 gallons should be kept for use when the sprayer tank needs to be emptied temporarily for repairs. It is advisable to purchase a reserve tank suitable for pesticide storage from Northern Tool and Equipment for use in these circumstances. The container should be properly labeled as to its contents if it is used. In addition, itmay be advisable to empty the tank contents using a transfer pump if the tank drain hole is inaccessible while the sprayer is mounted on the ATV.

Before attempting to service the sprayer:

1.

Personal

Wear personal protective equipment as directed on the chemical label while

 

protective

servicing your sprayer.

 

equipment

 

2.

Review

Review the Troubleshooting Table below for the type of problem you are

 

troubleshooting

experiencing. However, DO NOT attempt to repair until the steps listed below

 

table

are followed.

3.

Empty and flush

If the cause listed for your problem is Clogged intake tube, Clogged suction

 

 

strainer, or Worn spray gun nozzle: empty the tank and flush the sprayer with

 

 

water as directed in the section, “Operation – Step Four”.

 

 

- In order to avoid accidental exposure to chemicals, never attempt to unclog

 

 

the intake tube or suction strainer, or service the spray gun nozzle, until the

 

 

tank has been emptied and the sprayer flushed with water.

4.

Disconnect

Disconnect power to the sprayer and be sure all system pressure is relieved

 

power/relieve

by squeezing the gun trigger.

 

pressure

 

5.

Perform repairs

Follow the directions provided in the troubleshooting table to repair the

 

 

sprayer.

 

 

NOTE: Never try to unclog the sprayer nozzle by blowing through it.

6.

Test after

After servicing, ALWAYS test the sprayer for leaks with plain water before

 

servicing

using.

PROBLEM

CAUSE

SOLUTION

 

Bad electrical connection

Check battery connections

 

Short in wires

Check condition of wires

Pump will not turn on

Motor hooked to battery

Ensure red wire is connected to

positive battery terminal. If not,

 

 

incorrectly

correct wiring, then remove pump

 

 

head and tighten offset bearing.

Low pressure

Worn spray gun nozzle

Replace spray gun

Improper pressure adjustment

Tighten pressure adjustment knob.

 

 

Clogged intake tube

Remove obstruction

Low flow

Clogged suction strainer

Clean suction strainer

Obstruction in inlet/outlet valves

Clean inlet/outlet valves

 

 

Leak in the system

Tighten leaking hose clamps/fittings

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents M268180M Hazard Signal Word Definitions Table of Contents Spraying Pesticides Intended UseChemical Application Safety Summary of Important Safety InformationGeneral Chemical Safety ATV Vehicle Handling Safety Chemical Accident Procedures Following items are found in the manual bag Closely inspect all contents in the shipping cartonUnpacking Step One Attach gauge AssemblyStep Two Attach gun hose to spray gun and pump Step Three Attach gun clips to tankStep Six Attach sprayer to vehicle Step Five Attach hose guide to tankPreparatory safety Preparatory safety steps Step Seven Connect power cords to vehicle batteryPrepare wire ends Separate powerVehicle battery To install battery clampsTogether Attach remote switchCheck and test completed assembly Step Eight Check and test completed assemblyCheck assembly Working conditionMachine Components General Chemical Safety Operation Important Safety InformationBefore Spraying Chemical Application SafetyDuring Spraying After SprayingATV Vehicle Handling Safety To be automatically linked to the nearest certified poison InhalationOperation Preparing the Sprayer for Each Use Important safety rulesSpray because the wind is too strong Operation Using the SprayerStep One Assess wind conditions and clear work area Ensure tank is flushed of all chemicals from prior uses Fill the sprayer using the following stepsStep Two Fill the sprayer Fill tank Check drainTurn on power Review safetyStep Three Operate the sprayer Ensure flowOperate spray gun as needed for application Proper Operation of the Spray GunImmediately Open until desired amount of agitation is achievedDrain tank Step Four Clean sprayer and decontaminate after useDecontaminate LaunderRemoving from storage StoragePreparing for storage Before attempting to service the sprayer TroubleshootingAny Questions, Comments, Problems or Parts Orders SpecificationsPart# Description Exploded View 268180 Rev. M

M268180M specifications

The North Star M268180M is a robust and versatile utility vehicle designed to meet the demands of various industries, including agriculture, construction, and outdoor recreational activities. This model is recognized for its unique blend of power, efficiency, and durability, which make it an ideal option for users seeking a reliable companion for their demanding tasks.

One of the standout features of the M268180M is its powerful engine, which provides robust performance across a range of terrains. The vehicle is equipped with a high-efficiency diesel engine that ensures low fuel consumption while delivering substantial torque. This makes it not only economical to operate but also capable of tackling heavy loads and challenging landscapes with ease.

The M268180M boasts advanced off-road capabilities, thanks to its impressive four-wheel-drive system and superior suspension design. This enables the vehicle to navigate rough and uneven terrain without compromising on comfort or stability. The all-terrain tires provide excellent grip, ensuring that the M268180M can handle mud, sand, and rocky surfaces without difficulty.

In terms of technology, the North Star M268180M is equipped with a user-friendly dashboard that provides essential information at a glance, enhancing the driver's control over the vehicle. Additionally, it features advanced safety systems, including robust braking mechanisms and roll-over protection, ensuring that operators can work safely even in challenging conditions.

Comfort is another key aspect of the M268180M, which is designed with ergonomically crafted seating and ample cabin space. The interior accommodates the driver and passenger comfortably, allowing for long hours of use without fatigue. Furthermore, it offers easy access and excellent visibility, making navigation simple and intuitive.

Durability is paramount in the design of the M268180M, which features a rugged frame and reinforced body to withstand the pressures of heavy-duty use. Its materials are chosen to resist wear and tear, ensuring longevity and reliability in various operating environments.

In summary, the North Star M268180M stands out with its powerful engine, advanced off-road capabilities, user-friendly technology, comfort-focused design, and exceptional durability. This utility vehicle is an excellent choice for those seeking a dependable, high-performance machine to handle their most demanding tasks efficiently.
Top Page Image Contents